Glen Dimplex Home Appliances Ltd 121R manual Installing Your Cooker

Page 2

Installing Your Cooker

Your Belling Cooker

Even if you have used an electric cooker before, it is important that you read

 

these instructions thoroughly before starting to cook, paying particular attention

 

to the installation and safety instructions.

 

Getting help

If you have any problems with installing, operating, or cooking with your Belling

 

Cooker, please check through these instructions thoroughly to make sure that

 

you have not missed anything. If you still need help, then please contact:

 

 

Belling Customer Care Centre

 

 

Stoney Lane

 

 

Prescot

 

 

Merseyside

 

 

L35 2XW

 

 

Tel 0844 815 3746

 

 

If your query relates to cooking then please write to the Senior Home

 

 

Economist at the same address.

 

 

Details of how to contact a Belling Approved Service Agent, should your

cooker

 

ever require maintenance, can be found in the ‘Care of your cooker’ section of

 

this book. Please quote the cooker model and serial number with all enquiries,

 

this can be found on the voltage label which is located on the outer back panel.

 

WARNING! For your own safety, make sure that these instructions on

 

installation, use and maintenance are followed.

 

 

We advise you to keep these instructions in a safe place for future reference. if

 

you sell or transfer ownership of this product, please pass on these instructions

 

to the new owner.

 

 

This appliance is not intended for use by persons (including children) with

 

 

reduced physical, sensory or mental capabilities, or lack of experience and

 

knowledge, unless they have been given supervision or instruction concerning

 

use of the appliance by a person responsible for their safety.

 

Unpacking

After unpacking your cooker, make sure that you remove all the packing from the

 

oven and grill compartment, and the packing from under the hob on radiant ring

 

models, and any stickers from the oven door and the hob. Examine your cooker

 

for any damage. If there is any damage to your cooker or anything is missing,

 

please contact your supplier for advice.

 

Locating the cooker

Your cooker must stand on a flat surface, or be fitted to the special Belling stand,

 

so that when it is in position the hob is level. Make sure that the cooker is stable

 

and cannot be rocked. If it is used between units, allow 10mm (3/8”) clearance

 

on each side. It must not be situated with either side closer than 150mm (6”) to a

 

wall or cupboard that is higher than the hob. Do not remove the cooker feet.

 

Any overhanging surface or cooker hood should be at least 450mm (18”)

above

 

the cooker hob. We do not recommend positioning the cooker below wall

 

cupboards, as the heat and steam from the cooker may cause damage to the cupboards and its contents. Make sure that the walls near the cooker are resistant to heat, steam, and condensation.

2

Image 2
Contents Baby Belling 121R Installing Your Cooker Connecting the cooker Electric shock if it is inserted into a socketAlways For Your Own SafetyNever Power on ControlsGrill control Using the ovenOven/grill pan and grid Oven shelfCare of your cooker Electrical load Power supplyNominal dimensions mm