3M 2250E, 2273E manual Cable Receiver Setup

Page 8

Press

to select Trace mode. Press again to select one or all of the

four frequencies. The display will alternate between displaying the selected frequency and the output signal current. It is best to choose the lowest frequency for direct connect with far-end ground and a high frequency for direct connect with no far-end ground.

Press

to select high output level for longer tracing distances and

deep cables.

Transmitter setup is finished, now go to LOCATING A BURIED

CABLE - RECEIVER SETUP (PAGE 10).

Page 7

Image 8

Contents Dynatel 2250E/2273E Advanced Cable Fault Locator Table of Contents Installing or Replacing the Batteries IntroductionInitial Receiver Configuration Receiver Battery TestWatt Output Transmitter Battery TestUsing External DC Power and 5 Watt Output Transmitter Setup Locating a Buried CableDirect Connect Method Cable Receiver Setup Now go to Locating a Buried Cable Receiver Setup DYNA-COUPLER MethodInduction Method Receiver Setup About Trace Modes Selecting Passive Power Frequencies Selecting Auxiliary FrequenciesUsing Current Indications During Locating Determining Cable Depth and CurrentLocating Sheath Faults 2273E only Cable path Red leg Locating AN Active Duct Probe ADP Determining ADP DepthLocating Markers while Tracing Cable Path Locating Markers using the ReceiverLocating EMS Markers Toning Aerial Faults Cable or Pair Identification Cable IdentificationPair Identification Optional Accessories Technical Information TransmitterReceiver EnvironmentalTelecom Systems Division Important Notice