Danby DBC514BLS owner manual Preparing, Enclosure, Electrical Requirements

Installation Instructions - Intergrated Application

Tools You Will

Need

	Safety Glasses			Level
		Gloves
FOR YOUR SAFETY:
While performing			Flashlight
installations described in
this section, gloves, safety				Carpenters
glasses or goggles should
			Measuring	Square
be worn.	Drill & Hole Saw set
			Tape
Preparing the	• It is recommended that you de		• The electrical oulet may be
Enclosure	not install the beverage center		positioned from within either
	into a corner (i.e. directly beside		side of the adjacent cabinetry, or
	a wall). This is to allow the		the rear of the shaded area (as
	door(s) to have a greater then		shown in Fig C.).
Electrical Requirements:	90° opening swing. A limited
	door swing will prevent the		• If the electrical outlet is located
The appliance must be	shelves from sliding out as		inside the adjacent cabinetry, cut
	intended, and may lead to dam-		a 1-1/2” diameter hole to admit
connected to an individual
	aging the door gasket(s).		the power cord. If the cabinet
properly grounded electrical
			wall is metal, the hole edge
outlet, protected by a 15 or
	• The rough cabinet opening		must be covered with a bushing
20 ampere circuit breaker or
	must be on a level floor area		or grommet.

time delay fuse.	and at least 25” deep by 24”
	wide. The opening should also
	have a height of at least 35”.

		1-1/2” dia. hole
		*if electical outlet
		is in adjacent
		cabinetry
					24”
35” From
					Min.
Underside of			2	”
Countertop to						Cabinets
	Floor	Electrical Access
						Square
						and
						Plumb

6”

24”

Fig C

8