Danby DWC516BLS owner manual Preparing the Enclosure, For Your Safety, Electrical Requirements

Installation Instructions - Integrated Application

Tools You Will

Need

				Level
FOR YOUR SAFETY:	Safety Glasses	Gloves	Philips
			Screwdriver
While performing				Flashlight
installations described in
this section, gloves, safety				Carpenter’s
glasses or goggles should
			Measuring	Square
be worn.	Drill & Hole Saw set
			Tape

Preparing the Enclosure

Electrical Requirements:

The appliance must be connected to an individual properly grounded electrical outlet, protected by a 15 ampere circuit breaker or time delay fuse.

Important: It is recommended that you install the wine cooler in a location that allows the door to have a greater then 45° opening swing. A limited door swing will prevent the shelves from sliding out as intended, and may lead to damaging the door gasket.

•The rough cabinet opening must be on a level floor area and at least 24” deep* by 12-1/2” wide. The opening should also have a height of at least 34-1/2”.

•The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig C.).

Note: If the electrical outlet is surface mounted (not flush) within the enclosure, the depth requirment for the installation will be affected.

•If the electrical outlet is located inside the adjacent cabinetry, cut a 1-1/2” diameter hole to admit the power cord.

Fig C
	1-½" dia. hole
	*If electrical
	outlet is in
34-½" From	adjacent	*
	cabinetry
Underside of
		2"
Countertop to
Floor	Electrical Access
		6"
	24"

*The listed depth requirment for the installation is assuming that the electrical outlet is located in the adja- cent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.

8