Danby DWC508BLS installation instructions Setting, Wine Storage, Shelf Instructions

OPERATING INTRUCTIONS (cont’d)

SETTING THE

TEMPERATURE Important: In the event of a power failure, wait 3 to 5 minutes before restarting.

•To switch the display between the Fahrenheit (°F) and Celsius (°C) scale, depress the ‘Set Upper’ and ‘Set Lower’ control buttons simultaneously for approximately five (5) seconds.

•The temperature range can be set as low as 39°F (4°C) or as high as 64°F (18°C) to suit your specific wine storage requirements. Each depression of the ‘Set Upper’ or ‘Set Lower’ button will allow you to adjust the temperature in 1° increments within the aforementioned range.

•You may view your ‘set’ temperature at any time by briefly depressing either the ‘Set Upper’or ‘Set Lower’ button.

WINE STORAGE	The Maximum Capacity* of the DWC508BLS is 50 (750mL) wine bottles.
	* When stocked as per instructions below.

In order to achieve the maximum storage capacity of fifty (50) bottles, it will be necessary to position 4 bottles on the top shelf as in Fig. A.

Next, arrange 8 bottles on the second to the sixth shelf, alternately as shown in Fig. B.

Finally, arrange 6 bottles on the bottom shelf as in Fig. C; this will allow for the total storage of fifty (50) 750mL wine bottles.

Fig A

Fig B

Fig C

SHELF	IMPORTANT!
INSTRUCTIONS	Do not cover any part of the shelves with aluminum foil or any other material that
	will prevent adequate air circulation within the cabinet.

To remove a rack from its locked position, tilt the rack as shown in Fig. D and pull outward

To re-install,ensure the rack is resting securely on the support brackets and push the rack inward until it locks into place.

Fig. D

5