7.INSTALLING REFRIGERATOR IN
ENCLOSURE
NOTE: DO NOT install the appliance directly on carpet- ing. Carpeting must be removed or protected by a metal or wood panel beneath the appliance, which extends at least the full width and depth of the appli- ance.
FIG. 3
The dimensions shown in FIG. 3 will give you adequate space for service and proper installation.
e
Refrigerator |
|
| Overall |
|
|
| Installation |
|
| Recess |
| Distance between | |
Model |
|
| Dimensions |
|
| Dimensions |
|
| Dimensions |
| topofcondenserand | ||
|
|
|
|
|
|
|
|
|
|
|
|
| top of refrigerator |
RM2191 | Height | Width | Depth | Height |
| Width | Depth | Height | Width | Depth | |||
|
| ||||||||||||
RM2193 |
| A | B | C | h |
| w | d | H | W | D | e | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| (Inches) |
| 1/4" | ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
| |
(mm) | 548 | 478 | 545 | 524 |
| 445 | 505 | 530 | 451 | 519 | 6 | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
A. INSTALLATION
The refrigerator must be installed in a substantial enclo- | FIG. 4 |
sure and must be level. When installing the refrigerator in |
|
the enclosure, all areas within the recess in which the |
|
refrigerator is installed must be sealed from the living |
|
space. |
|
Make sure that there is a complete seal between the front |
|
frame of the refrigerator and the top, sides and bottom of |
|
the enclosure. A length of sealing strip is applied to the rear |
|
surface of the front frame for this purpose. Also apply a |
|
sealing strip to the foremost floor of the enclosure and |
|
apply a second sealing strip to the bottom of the trim strip |
|
on the front base as shown in FIG. 4. The sealing should |
|
provide a complete isolation of the appliance's combustion |
|
system from the vehicle interior. |
|
B.CONDENSATE DRAIN HOLE:
A hole must be drilled through flooring "L" (FIG. 2). This hole must be drilled in the
NOTE: Be careful not to damage the sealing strip applied to the floor of the enclosure when the refrigerator is put in place.
4