Dometic RM36O service manual Lining

9

Replacement of door gasket (Fig. 9)

1.Pull the old gasket out from the door frame.

2.Make sure that no gasket parts are left in the groove.

3.Beginning in one of the corners, fit the new gasket by pressing it into the groove.

Fig.9

Reversing outer door (Fig. 10)

1.Remove the plastic cover (1) by loosening the screws (2) underneath.

2.Remove the upper hinge pin (3).

3.Remove the door and move the lower hinge pin (4) to the other side.

4.Fit the door and press the upper hinge pin

(3)into the adequate hole.

For two-door refrigerators the middle hinge and the travel latch should change position.

Fig.10

Replacement of evaporator door on RM360,

RM460, RM660 (Fig. 11 and 12)

1.Pry the spring housings (B) away from the li- ning so that it snaps out and turn the spring housing downwards 180'.

2.Push the carrier (A) inwards by means of a blunt mandrel or pin and remove the shutter.

3.Mount the new shutter in close position first on one side, making sure that the cross slots engage in the cross on the hinge plate (C).

4.Press the carrier on the opposite side so that the hinge plate on the shutter can be pushed over it. See that the crosses engage.

5.Turn the spring housing round and up until the small tag (D) snaps into the slot into the

lining. Fig.11 Fig.12