Whirlpool ED25EM manual Install properly, Level refrigerator-freezer, Remove sales labels

Install properly.. .

1.Allow %” (.2 cm) space on each srde and at top for ease of installation.

2.The refrigerator back can be flush against the wall.

3.If the refrigerator is to be against a wall, you might want to leave enough space so the door can be opened wider.

d.. . . . *

Level refrigerator-freezer.. .

Right to Raise;

Left to Lower

I, Remove base grille [see page 8).

2.To raise front, turn each screw to the right

3.To lower front, turn each screw to the left.

4.Check with level.

Remove sales labels.. .

Remove the Consumer Buy Guide label, tape and any inside labels before using the refrigerator

To remove any remaining glue:

I. Rub brrskly with thumb to make a ball then remove.

OR

2 Soak area with dishwashing detergent solution (1 teaspoon detergent In 1quart warm water) before removing glue as described In step 1

DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-

bon tetrachloride, etc. These can damage the material.

NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.

Do not remove the Tech Sheet fastened under the refrigerator at the front.

Clean your refrigerator before using it. See cleaning instructions on page 9

Refrigerator

Power Cord

Recommended

Grounding Method

A 115 Volt, 60 Hz., AC only, 15 or 20 ampere fused electrrcal supply is required. It is recommended that a separate circuit serving only this applrance be provided.

Do not use an extension cord. Use a receptacle which cannot be turned off wlth a switch or pull chain. See individual electrical requirements and

grounding instruction sheet in your literature package.

4