Whirlpool EL11PC manual Changing the light bulb, Adjusting the refrigerator, Shelves, Trays

Changing the light bulb.. .

Unplug lhe refrigerator before changing the llghl bulb.

I, Reach behind control console to find bulb.

2.Remove bulb.

3.Replace with a 40.watt [maximum] appliance bulb.

Adjusting the refrigerator

1 First, remove fo& from shelf.

2.Slide shelf straight out to stop.

3.Lift front.

4Shde the rest of the way out

shelves...

Shelf Stop a/m

Replacing	Shelf:
1 Fit back of shelf on top of guides with wire stops
on the bottom of guides		!w	‘Shelf	Guide
2 Ltft front,	slide shelf In until It clears guide stops

Removing crisper and crisper

cover.. . Lift the Front. Then the Back.

Removing Crisper:

l Slide crisper straight out.

Remove Cover:

I. Lift back, then slide to the rear until the front can be Med.

2.Lif-tcover up and out.

Replacing Cover:

I, Slide the front cover tabs into the back of the front supports on the refrigerator wall.

2.Lower back into place.

Ice cube	trays...
To remove	ice:	If cubes		are	not used,	they	may	shrink	The moving
1. Hold tray	at both ends.	cold	air starts		a slow evaporation.			The	longer cubes
2 Slightly twist.		are	stored,	the	smaller	they	get.

Souncls you may hear.. .

Your new refrlgerotor may make sounds that your old one dldn t Because the sounds ore new to you. you might be concerned about them Don t be Most of Ihe new sounds are normal Hard surfaces llke the floor. walls and coblnets can make the sounds seem louder

The followlng chart describes the kinds of sounds that might be new to you and what may be maklng them

Poutbte Sounds:

l Water Sounds:

l Running Sounds:

Probable Causes:

When the refrigerator stops running. you may hear gurgling In the tubing for a few minutes after tf stops

Your refrigerator has a high-efflclency compressor and motor If WIIIrun longer than older designs It may even seem to run most of the time

6