Whirlpool ET22ZK Install properly, Level refrigerator-freezer, Remove sales labels, Clean it

Install properly.. .

I, Allow % inch (1.25 cm) space on each side and at the top of the refrigerator for ease of installation.

2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wrder

3.The refrigerator back can be flush agarnst the wall.

Level refrigerator-freezer.. .

Levelling SK4 1

Right to Raise;

Left to Lower

I. Remove base grille [see page 7):

2.To raise front, turn each screw to the rrght.

3To lower front, turn each screw to the left.

4Check with level

Remove sales labels.. .

Remove the Consumer Buy Gurde label, tape and any lnslde labels before using the refrigerator

To remove any remaining glue:

1.Rub briskly with thumb to make a ball then remove

OR

2.Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water) before removing glue as described in step 1.

DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachloride, etc. These can damage the material.

NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.

Do not remove the Tech Sheet fastened under the refrigerator at the front.

Clean it.. .

Clean your refrigerator before using tt.See cleaning instructions on page 8 and 9

Plug it in...

J-prong grounding type wall receptacle

grounding plug

t

Refrigerator

Power Cord

RECOMMENDED GROUNDING METHOD

A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused

and properly grounded electrical supply is re-

quired. It is recommended that a separate circuit serving only this appliance be provided

Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch

or pull chain. See individual electrical requrre- ments and grounding instruction sheet in your Irter- ature package.

A