Before using your refrigerator
1. Remove sales labels...
Remove the Consumer Buy Guide label, tape and any inside labels before using the refrigera- tor. To remove any remaining glue:
1.Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with liquid hand dishwashing de- tergent before removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech sheet fastened under
the refrigerator | at the front. | ., *;, |
‘C”J’iy rw.yply, /, | ||
2. Clean | it... |
|
Clean your refrigerator before using it. See cleaning instructions on page 8.
@zsaII | ,i&&LEWO. ,. |
3. Plug it in..: | |
GROUNDING | |
TYPE WALL | RECEPTACLE |
REFRIGERAfOii | &PRONG |
POWER CORD | GROUNDING PLUG |
RECOMMENDED GROUNDING METHOD
A 115Volt, 60 Hz.,AC only 15 or 20 ampere fused and properly grounded electrical supply is re- quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.
4. Iustall properly...
1.Allow 3 inches (7.5 cm) between overhead cab- inets and the refrigerator top.
2.Allow at least an inch (2.5 cm] between the re- frigerator condenser on the back and the wall.
3.Allow YZinch (1.25cm) on each side of the refrig- erator for ease of installation.
4.If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider.
5.If your refrigerator has an ice maker, make sure ice maker water supply has been connected. Refer to Installation Instructions.
5. Level refrigerator-freezer...
EVELLING LEG
WER
This refrigerator has 2 threaded levelling legs that are shipped in a separate package.
1.Screw these legs all the way into bolt holes at the bottom corners of refrigerator. Roll refrigera- tor into place.
2.Lower legs just enough to lift rollers off floor.
3.Adjust each leg until the refrigerator won’t rock.
4.Adjust front legs to level the refrigerator.
-To raise corners, turn legs in direction shown.
-To lower corners, turn legs in direction shown.
5.Check with level.
4