Whirlpool ETL8VK, ETl8XK manual Install Properly Level refrigerator-freezer, Clean it, Plug it

Install	properly..	.	Level refrigerator-freezer..		.
			Use Screwdriver	Leveling screw
			to Adjust

Right to Raise;

Left to Lower

1 To raise front, turn each screw to the right 2 To lower front, turn each screw to the left 3 Check with level

1 Allow 3 Inches (7.5 cm] between overhead cabi- nets and refrigerator top

2 Allow at least an inch (2.5 cm] between the refrigerator condenser on the back and the wall.

3. Allow K inch (1.25 cm] on each side of the refrigerator for ease of Installation.

4 If the refrigerator ISto be against a wall, you might want to leave extra space on the hinge side so the door can be oDened wider.

Clean it.. .

Clean	your	refrigerator
before	using	it
See cleaning		instructions	A
on page	8,	i

Plug it in...

3-prong grounding type wall receptacle

Remove sales labels.. .

Remove the Consumer Buy Guide label, tape and any inside labels before using the refrigerator.

To remove any remaining glue:

1 Rub briskly with thumb to make a ball then remove

OR

2.Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water) before removing glue as described in step 1

DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-

bon tetrachloride, etc. These can damage the material.

NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.

Do not remove the Tech Sheet fastened under

the refrigerator at the front.

Refrigerator

Power Cord

RECOMMENDEDGROUNDING METHOD

A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused

and properly grounded electrical supply IS re-

quired. It IS recommended that a separate circuit serving only this appliance be provided.

Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instructlon sheet in your liter- ature package