Whirlpool ET22MK manual Removing the crispers and crisper covers, Reversing the door swing

Removing the crispers and crisper covers.. .

lSlide crispers straight out to stop l Lift the front

l Slide the rest of the way out. l Replace In reverse order

Covers are held In place by two pegs at the back and two notched tabs in front.

Push the Tab

to Clear the Cover.

Reversing the door swing.. .

You can change the hinges on your refrigerator SO the doors open the other way. Refer to the instruction sheet Included with your refrigerator

Ice cube trays.. .

To remove ice:

lHold tray at both ends.

. Slightly twist

If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.

Snap Back into Place.

lPress front tabs out of the way l Lift cover front.

l Lift back off the pegs.

l Replace In reverse order.

Optional automatic

On

L

\

L

L

ice maker.. .

I

Raise Signal

Arm to Stop Ic e Maker.

Lower Signal

Arm to Start It.

The center leg can be made shorter or longer to help level the crisper covers, If necessary. Turn the leg clockwise to make It longer. Turn It counter- clockwise to shorten It

Changing the light bulbs...

Before removing the light shield for cleaning or for

replacing the bulb. unplug the refrigerator. Use OppiionCe bLJ/bS On/y

Push in the Center;

light bulb behind light shield:

l Push lightly on the top center of the light shield until the notched tab unhooks from the control panel.

l Pull down on the shield until the tab clears the control panel.

lLift the back hooks out of their slots.

l Replace with a 40-watt appliance bulb l Replace light shield in reverse order.

Light bulb behind crispers:

l Remove crispers and crisper covers.

lBulb is on back wall of refrigerator.

l Replace with a 40.watt appliance bulb. l Replace crisper and crisper cover.

lPlug In the refngerator.

If you have the automatic ice maker accessory or plan to add one later (Part No. ECKMF-6). there are a few things you will want to know,

l The ON/OFF lever is a wire signal arm. Down.. foe making Ice automatically. Up...toshut off the ice maker.

l Shake the bin occasionally to keep cubes sepa- rated, and to obtain Increased storage capacity.

l It is normal for Ice crescents to be attached by a corner. They will break apart easily.

l You will hear water running when ice maker is working. You’ll hear Ice fall Into the bin. Don’t let these sounds bother you.

l The ice maker will not operate until the freezer IS cold enough to make ice. This can take overnight.

l Because of new plumbing connecttons, the first ice may be discolored or off-flavored Discard the first few batches of ice

l If ice ISnot being made fast enough and more Ice ISneeded, turn the Temperature Control toward a higher number. Wait a day and, If necessary, turn the Air Control toward A.

l If you remove the Ice bin, raise the signal arm to shut off the Ice maker. When you return the bin. push it all the way In and lower the arm to the ON position.

l If cubes are stored too long, they may develop an off-flavor. .Ilke stale water. Throw them away They ~111be replaced Cubes in the Ice bin can also become smaller by evaporation.