Whirlpool 3ET22RK Removing the base grille To remove the grille, Ondenser coils, Ice cube trays

Page 9

Removing the base grille

	1. Open the freezer door.
	2.	Pull grille out.
	3.	Do not remove		Tech Sheet fastened behind
ondenser coils		grille.
	To replace		grille:

	1. Line up grille support tabs with metal clips.
	2.	Push firmly to snap into place.
	3.	Close the door.
	See cleaning instructions for defrost pan and
	condenser coils on page 11.
	Reversing		the door swing
	You can change the hinges on your refrigerator
	so the doors open the other way. Refer to the
	instruction sheet included with your refrigerator.
	Ice compartment			door
	Pull the ice compartment door panel out from the
	bottom and slide it to the rear.

If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.

1.Hold tray at both ends.

2.Twist slightly.

Image 9

Contents Use& CareGuide Contents It is your responsibility to be sure your refrigerator ImportantSafetyInstructionsBeforeUsingYourRefrigerator Setting the controls UsingYourRefrigeratorChanging the control settings ConditionAdjusting the refrigerator shelves Using Your Refrigerator Glass shelves CarefulAdjusting the shelf and bin glides Exterior moisture controlAdjusting the crisper humidity control Adjusting the door bins To removeTo replace To remove the coverChanging the light bulbs Electrical Shock Hazard Using Your Refrigerator ContmuedTo change refrigerator light To change freezer lightOndenser coils Removing the base grille To remove the grilleTo replace Grille Reversing Door swingSlight hum, soft hiss Using Your Refrigerator Sounds you may hearClicking or snapping sounds Water soundsHOW to Clean CleaningYourRefrigeratorPart What to USEType FoodStorageGuideShort holidays CaringForYourRefrigeratorLong holidays MovingIfYouNeedServiceOrAssistance Page Full FIVE-YEAR Warranty Whirlpool will PAY forWhirlpool will not PAY for