Install properly... | Remove sales labels. .. |
| |||
| Remove the Consumer Buy Guide label, tape | ||||
| and any | inside | labels | before | using the re- |
| frigerator. To remove any remaining glue: | ||||
| 1. Rub briskly with thumb to make a ball then | ||||
| remove. |
|
|
|
|
| OR |
|
|
|
|
| 2. Soak | area with | liquid | hand | dishwashing |
| detergent before removing glue as described | ||||
| in step | 1. |
|
|
|
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTIONS LABELS INSIDE YOUR REFRIGER- ATOR.
Do not remove the Tech sheet tastened under the refrigerator at the front.
1.Allow YZinch (1.25 cm] space on each side and
at the top of the refrigerator for ease of installation.
2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider.
3.The refrigerator back can be flush against the wall.
Level refrigerator-freezer...
USE SCREWDRIVER
TO ADJUST
FRONT ROLLER
VELLING SCREW
IGHT TO RAISE;
LEFl TO LOWER
1.Remove base grille (see page 8).
2.To raise front, turn screw in direction shown.
3.To lower front, turn screw in the direction shown
4.Check with level.
5.Replace base grille (see page 8).
Clean it... | m |
Clean your refriger- ator before using it.
Plug it in...
REFRIGERATOR | 3- PRONG |
POWER CORD | GROUI NDING PLUG |
|
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate cir-
cuit sewing only this appliance be provided.
Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.
4