Whirlpool 8ET8MTKXKT00 manual CrisperHumidityControl, Freezer Shelf, To remove the crisper

Page 19

3.Tilt cover up at the front.

4.Pull cover forward and out.

To replace the cover:

1.Fit notches and rear edge of cover over rear and center crossbars on the shelf.

2.Lower cover into place.

3.Replace the meat drawer.

CrisperandCrisper Cover

(onsomemodels)

To remove the crisper:

1.Slide crisper straight out to the stop.

2.Lift the front.

3.Slide crisper out the rest of the way.

4.Replace the crisper by sliding it back in fully past the drawer stop.

To remove the crisper cover:

1.Remove both crispers.

2.Holding glass insert firmly, grasp one side of crisper cover and lift the other side up from the bottom.

3.Slide the glass insert out to remove.

4.Lift cover frame up and remove.

NOTE: Before reinstalling the cover, make sure the U-shaped reinforcement bar is reinstalled.

To replace crisper cover:

1.Fit back of cover frame into supports on side walls of the refrigerator.

2.Lower front of the cover frame into place.

3.Slide rear of glass insert into cover frame and lower front into place.

CrisperHumidityControl

(onsomemodels)

You can control the amount of humidity in the moisture- sealed crisper. Adjust the control to any setting between LOW and HIGH.

■LOW (open) lets moist air out of the crisper for best storage of fruits and vegetables with skins.

■HIGH (closed) keeps moist air in the crisper for best storage of fresh, leafy vegetables.

Freezer Shelf

(onsomemodels)

To remove the shelf:

1.Lift entire shelf slightly.

2.Move shelf all the way to one side.

3.Tilt other side up and out of shelf supports.

4.Pull shelf up and out.

To replace the shelf:

1.Tilt the shelf and insert into freezer compartment.

2.Insert one end of the shelf all the way into the center of the shelf supports.

3.Lower other end of shelf and insert into the shelf supports.

19

Image 19

Contents 2200594A Use& Care GuideContents Your safety and the safety of others is very important Refrigerator SafetyBefore you throw away your old refrigerator or freezer Parts and Features Removing Packaging Materials Space RequirementsRead all directions carefully before you begin Electrical RequirementsTo a Water Source Recommended Grounding MethodStyle Connecting to refrigeratorTo remove doors from hinges ReversingtheDoor SwingTo replace doors Bottom Hinge Reversingthe DoorHandlesTop Hinge Center HingeStyle To remove the base grille Base GrilleDoor Closing Door AlignmentUnderstanding Sounds You May Hear Using Your RefrigeratorEnsuringProper Air Circulation Adjusting ControlSettings Setting the ControlsStoring Fresh Food Food StorageGuideStoring Frozen Food RefrigeratorShelves Refrigerator FeaturesFreezing Slide-out shelves on some models Lateral Adjustable ShelfShelves and shelf frames Drop-in Door Rails Door RailsDoorBins Snap-on Door RailsFlip-up Door Shelf Adjustable Utility Compartment & TrayMeatDrawerandCover To remove the crisper cover CrisperHumidityControlFreezer Shelf To remove the crisperTo replace the freezer floor Pull-out Freezer FloorIce MakerOperation To remove the freezer floorEnergy Saving Tip To clean your refrigeratorAdditional cleaning tips are listed below Changing the LightBulbsTo change freezer light on some models PowerInterruptionsVacationandMovingCare VacationsLights do not work Trouble ShootingMoving Your refrigerator will not operateRefrigerator seems to make too much noise Motor seems to run too much Ice maker is not producing iceIce maker is producing too little ice There is interior moisture build-up Temperature is too warmOff-taste or odor in the ice Divider between the two compartments is warmIf you need replacement parts Assistance Or ServiceFor further assistance Whirlpool Corporation will not pay for Whirlpool Refrigerator Warranty