Adjustable Flip-up Shelf, Deli Drawer

To remove the shelf:

NOTE: The shelf is heavy and must be removed using both hands.

1.Hold the back of the shelf with one hand.

2.Lift the front of the shelf with the other hand to a 45° angle and lower it slightly to release it from the upper channel of the track. Pull the shelf straight out.

To remove and replace the shelf track:

1.Remove the shelf track by lifting both sides of the track slightly and pulling the track straight out.

2.Replace the track by guiding the track hooks into the shelf support slots on the back wall.

NOTE: Make sure that both sets of track hooks are in the slots and that the slots are parallel with each other.

3.Push the track back and down securely into the shelf supports.

To replace the shelf:

NOTE: Make sure that both of the rear shelf slides are securely in the track before letting go of the shelf. The lateral shelf may be difficult to install if the track is placed too close to the refrigerator ceiling. Reposition the track on a lower rung until the shelf can be tilted enough to easily slide into the track.

1.Hold the shelf at the front and tip the front at a 45° angle to the track.

2.Insert both of the rear shelf slides into the upper channel of the track, and lower the front of the shelf into place.

Flip-up Shelf

(on some models)

1.To raise the shelf, pull forward on the lever located at the bottom front of the shelf and lift until the shelf locks into the vertical position.

2.To lower the shelf, lower the shelf until it is latched securely in place.

Adjustable Flip-up Shelf

(on some models)

To raise and lower the shelf:

1.Raise the shelf by first sliding it back and down to make it half-width. (You can use the shelf in this position to allow taller items to be stored on the shelf below.)

2.Lift the front of the shelf until it fits securely in place against the back wall.

3.Lower the shelf securely back into position.

4.Pull the front of the shelf forward until it fits into place.

Deli Drawer

(on some models)

The deli drawer stores raisins, nuts, spreads, and other small items at normal refrigerator temperatures.

To remove and replace the deli drawer:

1.Remove the deli drawer by sliding it straight out to the stop. Lift the front and slide the drawer out the rest of the way.

2.Replace the deli drawer by sliding it back past the stop.

Convertible Vegetable/Meat Drawer,

Crisper and Covers

(on some models)

To remove and replace the crisper and convertible vegetable meat drawers:

1.Slide crisper or meat drawer straight out to the stop. Lift the front of drawer with one hand while supporting the bottom of drawer with other hand and slide the drawer out the rest of the way.

2.Replace the crisper or meat drawer by sliding it back in fully past the drawer stop.

HIGH

LOW