Whirlpool GMC305, RMC305, RMC275, GMC275 manual Electronic Oven Control

ELECTRONIC OVEN CONTROL

1 2 3 4

5

	LOWER OVEN
		CUSTOM
BAKE		BROIL	TEMP
		AUTO
		CLEAN
COOK		DELAY	STOP	HR
		START
TIME		TIME	TIME

C

F

HEAT CONVECT		ON	TIMER	STOP
DELAY BAKE			DOOR LOCKED CLEAN
TIMED BROIL	START ?		COOK	TIME
	TIMER			START
TIMER
SET		OFF		ENTER
MIN				OFF
CLOCK	LIGHT
				CANCEL

			1	2	3
MICROWAVE OVEN			4	5	6
MICRO	REHEAT DEFROST		7	8	9
TIME
		AUTO	ADD	0	COOK
CRISP	BROIL		MINUTE QUANTITY		POWER
		COOK
			START		OFF
POPCORN	WARM	MEMORY		COOK A
(3 SIZES)	HOLD		ENTER	BIT MORE	CANCEL

67 8 9 10 11 12

1.	Oven Setting Pads	5.	Microwave Oven Controls	9.	Clock Pad
2.	Temperature Pad	6.	Electronic Clock Control	10.	Light Pad
3.	Timer Set and Off		Pad	11.	Off/Cancel Pad
		7.	Hour Pad
4.	Electronic Display			12.	Start/Enter Pad
		8.	Minute Pad

Display

When power is first supplied to the appliance, “PF” will appear on the display. Press OFF/CANCEL to clear.

Any other time “PF” appears, a power failure has occurred. Press OFF/CANCEL and reset the Clock if needed.

When the oven is in use, the display shows preheat time and the temperature and oven setting.

When the oven is not in use, the display shows the time of day.

When using COOK TIME (on some models), the display will show either hours and minutes, or minutes and seconds.

Clock

This is a 12 hour clock and does not show a.m. or p.m.

To Set:

Before setting, make sure the oven, Timer and Timed Cooking are off.

1.Press CLOCK.

2.Press the HR or MIN “up” or “down” arrow pads to set the time of day.

3.Press CLOCK or START/ENTER.

Start/Enter

The START/ENTER pad begins any oven function except the Timer. If not pressed within 5 seconds after pressing a function pad, the “START?” indicator light will flash as a reminder. On some models, “START?” will appear on the display.

If not pressed within 4 to 5 minutes (depending on your model) after pressing a function pad, the oven display will return to the time of day mode and the programmed function will be cancelled.

Off/Cancel

The OFF pad stops any function except the Clock, Timer and Control Lock.

To Disable:

The clock time can be disabled so that it does not show on the display. To disable, press and hold CLOCK for 5 seconds. To display the clock time again, press and hold CLOCK for 5 seconds and the time of day will show on the display. The clock time should not have to be reset.

Tones

Tones are audible signals, indicating the following:

One tone

■Valid pad press

■Oven is preheated

■Function has been entered

Three tones

■Invalid pad press

Four tones

■End-of-cycle

■Reminder, repeating each minute after the end-of-cycle tones

6