Whirlpool DU8150XX Spray arm not rotating treely, Not enough detergent or improper detergent

Common Dishwashing Problems

Continued

Dishes not washing clean

Water is not hot enough

Water temperature should be at least 140°F (60°C). Set water heater thermostat to a higher setting. Run water at sink until hot before starting.

Improper loading

Make sure dishes and glassware are loaded so spray reaches all surfaces and items drain properly. Do not overload. Do not nest items.

Make sure large items do not block spray from reaching detergent dispensers.

Spray arm not rotating treely

Check spray arm to make sure it turns freely after loading. Be sure a utensil is not sticking out the bottom of the silverware basket and blocking the sorav arm from turninn

Not enough detergent or improper detergent

Use more dishwasher detergent. Use detergent with highest available phosphorus content.. especially with hard water.

“Old” detergent

Use only fresh dishwasher detergent. Store tightly closed container in cool, dry place. Discard old detergent. Do not fill dispensers until ready to start dishwasher.

Water pressure may be low, dishwasher is not filling properly

If water pressure is low, do not use water for other purposes while dishwasher is running (to assure correct fills).

Cloudy tilm on glassware, etching - permanent corrosion

Too much detergent in soft water

Check for rainbow hue on glasses. A rainbow

hue is the first sign of etching (corrosion of glass). Reduce the amount of dishwasher detergent.

Use a detergent with a lower phosphorus content.

Inadequate rinsing

If water pressure is low do not use water for other purposes while dishwasher is running (to assure correct water fills). Make sure dishes and glass- ware are loaded properly to assure adequate rinsing and draining. Do not overload.

Dishes 8 interior of dishwasher yellow or brown

Iron or manganese in water Temporary remedy:

1. Set emptv dishwasher for a “onewash” cvcle.

2.Start dishwasher and unlatch door to stop it when it has filled for the wash part of the cycle.

3.Add ‘/4to !I2 cup (120 to 240 mL) of citric acid crystals (usually available in drugstores).

4.Close and latch door to complete cycle.

Permanent solution: Install an iron or manganese filter or water softener to home water supply.

Rust spots on stainless steel -OR - Dark spots on flatware: stainless steel, silver plate, or sterling

Allowing salty or acidic foods s&h as mayonnaise, vinegar, fruit juices, salad dressings, milk products to remain on flatware

Rinse flatware that is to stand for several hours before washing (use the Rinse & Hold Cycle). Clean stained items with silver polish and t-e-wash. Do not put stainless steel and silver flatware in the same silverware basket compartment. Direct contact between these metals can cause perma- nent damage to the silver.

Undissolved detergent coming in contact with flatware

Remove spots with silver polish. Avoid spilling concentrated detergent on wet flatware.

Bronze tarnish on silverplate

Silverplate is worn off. Exposed base metal takes on a bronzed hue

Remove tarnish with silver polish. Have silver replated.

Water left in bottom of dishwasher above grate

Dishwasher cycle not completed

Allow dishwasher to complete cycle. Some remaining water is normal and keeps seals from drying.

Clogged drain air gap

Some plumbing bodes require use of a drain air gap between an undercounter dishwasher and the drain system of the house. The air gap is usu- ally located above the sink or on the top of the counter near the dishwasher to prevent the pos- sibility of water backing up from the drain into the dishwasher due to a plugged drain. The drain air gap is not a part of the dishwasher and is not covered by the dishwasher warranty. The drain air gap should be kept clean to ensure proper drain- ing of the dishwasher.

14