Whirlpool DU78OOXS manual Selecting a cycle, Option Selectorbuttons

Before starting your dishwasher -

1.Read “Important Safety Instructions” on page 2 before starting your dishwasher.

2.Spin the Upper Spray Arm to make sure nothing will stop it from turning freely.

3.Push door firmly when closing and it will automatically latch.

4.Run hot water at sink nearest dishwasher

until it is hot. Turn it off. CYCLE SELECTORBUTTONS

Starting your dishwasher

OPTION SELECTORBUTTONS

1.Push a Cycle Selector Button for the desired cycle.

2.Push Option Selector Button for desired option or options. (Use AIR DRY for RINSE & HOLD Cycle.]

3.Turn Cycle Control Knob clockwise to point to a desired cycle. You will feel a definite stop at each cycle mark.

-POTS & PANS and HEAVY WASH Cycles share the same spot on the dial, CHINA CRYSTAL and LOW ENERGY WASH Cycles also share a spot on the dial. The Cycle Selector Button determines which cycle operates.

The dishwasher will automatically start the selected cycle.

NOTE: Options may be changed or cancelled

by pushing the Option Selector Button(s) again.

Selecting a cycle

POTS & PANS Cycle

Maximum cleaning for cooked- or baked-on foods. Timer delays while

the dishwasher automatically heats the water to 145°F (63°C) in both washes and the last rinse [marked ‘1. Cycle time will be about 11/2to 2

hours, depending on time needed to heat water.

HEAVY WASH Cycle

A double wash for heavily soiled loads. Cycle time is about 75 minutes.

NORMAL WASH Cycle

For normal, everyday soiled loads. (The Energy Guide Label data is based on this cycle.) Cycle time is about 65 minutes.

LOW ENERGY WASH Cycle

For pre-rinsed or lightly soiled loads. Cycle time is about 60 minutes.