Whirlpool GU970 manual Cancelinga Cycle, Changing a Cycle orSetting, Adding ItemsDuringa Cycle

		Use this cycle for loads					Use
		with normal amounts of					covered
		food soil. (The energy-					detergent
		usage label is based on					dispenser
		this cycle.)					section.
Pre-	Rinse		Main	Rinse	Purge†	Final	Dry	Time	Water
Wash			Wash			Rinse		(min)	Usage
									(gal/L)
						140°F		61*	4.8-8.6/
						(60°C)		Light	17.4-32.7
			●		●	●	●	Soil
		Use this cycle for pre-					Use
		rinsed or lightly soiled or					covered
		for china and crystal					detergent
		loads. The cycle uses a					dispenser
		single wash and gentle					section.
		dry. The heating element
		cycles on and off.
Pre-	Rinse		Main	Rinse	Purge†	Final	Dry	Time	Water
Wash			Wash			Rinse		(min)	Usage
									(gal/L)
						130°F		58*	4.8-8.6/
						(54°C)		Light	17.4-32.7
			●		●	●	●	Soil
		Use this cycle for pre-					Use
		rinsed or lightly soiled					covered
		loads which do not					detergent
		require drying. No drying					dispenser
		options are available for					section.
		this cycle. The cycle uses
		a single wash.
Pre-	Rinse		Main	Rinse	Purge†	Final	Dry	Time	Water
Wash			Wash			Rinse		(min)	Usage
									(gal/L)
						140°F		26*	4.8-6.9/
						(60°C)		Light	18.2-26.1
			●		●	●		Soil
		Use this cycle for rinsing					Do not use
		dishes, glasses, and					detergent
		silverware that will not be					with this
		washed right away.					cycle.
Pre-	Rinse		Main	Rinse	Purge†	Final	Dry	Time	Water
Wash			Wash			Rinse		(min)	Usage
									(gal/L)
								10	2.2-4.3/
				●				Light	8.2-16.4
								Soil

†A small amount of water runs through the pump to remove soil particles.

Cancelinga Cycle

Anytime during a cycle, press

CANCEL glows. The dishwasher pauses for about 5 seconds and starts a 2-minute drain (if needed). Let the dishwasher drain completely. The light goes off when the dishwasher finishes the drain.

To stop the drain

You can press CANCEL again to stop the drain immediately. Remember to drain the dishwasher before starting a new cycle.

NOTE: A small amount of water remains in the dishwasher. This is normal.

To clear the indicators

Press CANCEL before starting the dishwasher to clear all options and cycles.

Changing a Cycle orSetting

During the first minute of a cycle

Press a new cycle and/or options.

After the first minute of a cycle

1.Press

CANCEL glows. The dishwasher pauses for 5 seconds and starts a 2-minute drain (if needed). Let the dishwasher drain completely.

2.Check the detergent dispensers. If the main wash cup has opened and the detergent washed away, refill the cups as needed.

3.Close the door.

4.Press a new cycle and/or options.

Adding ItemsDuringa Cycle

You can add an item anytime before the main wash starts. Open the door and check the detergent dispenser. If the main wash section is still closed, you can add items.

To add items

1.Lift up the door latch to stop the cycle. Wait for the spraying action to stop before opening the door.

2.Open the door. If the main wash detergent dispenser is still closed, add the item.

3.Close the door, but do not latch it. Wait 30 seconds for the air in the dishwasher to warm up. This reduces the amount of moisture escaping from the vent when restarting a cycle.

4.Close the door firmly until it latches. The dishwasher resumes the cycle after about a 5-second pause.

12