Connections, Operation, Maintenance, Specifications

CONNECTIONS

1.Connect the power cord to the auxiliary power outlet on the rear panel of your amplifier or receiver or to a household AC outlet.

2.Connect the unit output terminals to the PHONO jack of your amplifier or receiver.

NOTE:

ŸBe sure to connect the ground terminal firmly to the amplifier or receiver.

ŸIf this connection is not made or is loose, a power source "HUM" will result.

1.Rotate the power dial clockwise to turn on the power, the speed indicator and the strobe-illuminator will light up.

2.Place a record on the slip mat, when playing a 45rpm record with a large center hole, place the 45-rpm adaptor on the center spindle.

3.Set the speed to match the record.

4.Remove the stylus protector, release the arm clamp.

5.Press the Start/Stop button, the turntable platter will start to rotate.

6.Move the tonearm over the desired groove.

7.When play is finished, move the tonearm to the arm rest, secure the tonearm with the arm clamp.

8.Press the Start/Stop button to stop the platter rotating, rotate the power dial to turn off the power.

∙For best results & proper care of your equipment use Stanton Vinyl Cleaner (VC-1) for your records and Stylus Cleaner Kit for styli (SC-4).

∙Clean the stylus periodically with a soft brush to prevent the accumulation of dust.

∙When the sound becomes distorted or noisy, check the stylus. If worn out, replace it with a new one.

∙Any volatile materials such as alcohol, thinner, benzine, etc., may remove the paint or damage the lustre, please avoid.

APPLICATION:

This specification applies to the direct drive turntable unit T.60

NOTE: Measurements can be carried out between 5 degC to 35 degC and 45% to 85% relative humidity.

TURNTABLE SECTION:
Type	2-speed full manual
Motor	8pole, 2phase,brushless DC motor
Speeds	331/3 and 45rpm
Wow and Flutter	Less than 0.15% WRMS (JIS WTD) with 331/3rpm
Pitch Controls	+/-10%
Starting Torque	More than 1 kgf.cm
Starting Time	Less than 1 sec. with 331/3rpm
Braking Time	Less than 1 sec. with 331/3rpm
Time for Speed Change	Less than 1 sec. from 331/3 to 45 rpm.
	Less than 1 sec. from 45 to 331/3 rpm.
Audio Output	Phono output