Whirlpool GDP8700XT manual Using Delay Start, Changing a setting, Clean Signal Light

Using DELAY START

1.Push desired Cycle Selector Button.

2.Push desired Option Selector Button(s).

3.Turn Control Knob clockwise to the number of hours (from 1 to 4 hours) you want the dish- washer to delay before the selected cycle starts.

4.Close and latch the door.

NOTES:

l You can add items while time is counting down. Close and latch the door. The timer will not advance if the door is unlatched.

lRINSE & HOLD and LOW ENERGY WASH Cycles cannot be delayed.

Changing a setting

You can change a setting anytime during any cycle.

1.Lift up on the door latch to stop the cycle. Don’t open the door until the spray arms stop spinning.

2.Turn the Cycle Control Knob clockwise to the cycle you want.

3.Be sure the detergent dispensers are filled properly for the new cycle.

4.Press door firmly to latch it. The dishwasher

will automatically start the new cycle.

The CLEAN Signal Light

The CLEAN Signal Light will come on when a washing cycle is complete.

To turn light off, turn the Control Knob clock- wise slightly until the light goes off.

To add a dish after starting

1.To be sure the added item is washed and rinsed, make sure the Cycle Control Knob has not passed LOW ENERGY WASH.

2.Lift up on the door latch to stop the cycle. Don’t open the door until the spray arm stops spinning.

3.Open the door and add the dish.

4.Close the door. Do not latch it. Wait 30 sec- onds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.

5.Press door firmly to latch it. The dishwasher will start from where it stopped.

10