Removing the base grille
To remove the grille: | Condenser coils |
1.Open refrigerator door.
2.Pull base grille forward to release the support tabs from the metal clips.
3.Do not remove Tech Sheet fastened behind the grille.
To replace the grille:
1.Line up grille support tabs with metal clips.
2.Push firmly to snap into place.
3.Close refrigerator door.
See cleaning instructions for defrost pan and condenser coils on page 15.
Reversing the door swing
You can change the hinges on your refrig- erator so the doors open the other way. Refer to the instruction sheet included with your refrigerator.
Understanding the sounds you may hear
Your new refrigerator may make sounds that your old one didn’t. Because the sounds are new to you, you might be concerned about them. Don’t be. Most of the new sounds are normal. Hard surfaces like the floor, walls and cabinets can make the sounds seem louder.
The following describes the kinds of sounds that might be new to you, and what may be making them.
Slight hum, soft hiss
You may hear the refrigerator’s fan motor and moving air.
Water sounds
When the refrigerator stops running, you may hear gurgling in the tubing for a few minutes after it stops. You may also hear defrost water running into the defrost water pan.
Running sounds
Your refrigerator has a
Clicking or snapping sounds
The thermostat makes a definite click when the refrigerator stops running. It also makes a sound when the refrigerator starts. The defrost timer will click when the defrost cycle starts.
12