Whirlpool ADP 451 manual Before Calling for Service, Technical problems General problems Noise

Page 21

Before Calling for Service

Technical problems

General problems

Noise

Fuse blown, or the

Replace fuse or reset circuit breaker. Remove any other

circuit breaker acted

appliances sharing the same circuit with the dishwasher

 

Power supply is not

Make sure the dishwasher is turned on and the door is

turned on

closed securely.

 

Make sure the power cord is properly plugged into the

 

wall socket.

 

 

 

Error code:E1;

Check that the water supply is connected properly and

Water pressure is low

the water is turned on.

 

Door of dishwasher

Make sure to close the door properly and latch it.

not properly closed.

 

 

Kink in drain hose

Check drain hose.

 

 

 

Filter clogged

Check coarse the filter

 

(see section titled " Cleaning The Filter ")

 

 

 

Kitchen sink clogged

Check the kitchen sink to make sure it is draining well.

 

If the problem is the kitchen sink not draining ,you may

 

need a plumber rather than a serviceman for dishwashers.

Improper detergent

Use only the special dishwasher detergent to avoid

 

suds. If this occurs, open the dishwasher and let suds

 

evaporate. Add 1 gallon of cold water to the tub. Close

 

and latch the dishwasher, then Start the "soak" wash

 

cycle to drain out the water . Repeat if necessary.

 

Spilled rinse-aid

Always wipe up rinse-aid spills immediately.

Detergent with

Make sure that the detergent is the one without

colourant was used

colourant.

Hard water minerals

To clean the interior, use a damp sponge with

 

dishwasher detergent and wear rubber gloves.

 

Never use any other cleaner than dishwasher

 

detergent for the risk of foaming or suds.

The affected items are

 

 

not corrosion resistant.

 

 

A programme was not

Always run the quick wash programme .

run after dishwasher

without any crockery in the dishwasher and

salt was added.

without selecting the Turbo function (if present),

Traces of salt have

after adding dishwasher salt.

gotten into the wash cycle.

 

 

 

The lid of the softer

Check the lip .Ensure the fix is fine.

is loose

 

 

A spray arm is

Interrupt the programme, and rearrange the items

knocking against

which are obstructing the spray arm.

an item in a basket

 

 

Items of crockery

Interrupt the programme,

are loose in the

and rearrange the items of crockery.

wash cabinet

 

 

This may be caused

This has no influence on the dishwasher function.

by on-site installation

if in doubt, contact a suitably qualified plumber.

or the cross-section of

 

 

the piping.

 

 

19

Image 21
Contents ADP Page Page POM Control Panel Dishwasher FeaturesWater Softener Adjusting Salt ConsumptionFill the Rinse Aid Dispenser Loading the Salt Into the SoftenerRinse Aid Dispenser Function of Rinse AidAdjusting Rinse Aid Dispenser When to Refill the Rinse Aid DispenserFunction of Detergent DetergentsDetergent Tablets Concentrated DetergentDetergent Dispenser Amount of Detergent to UseFill in Detergent How To Use The 3IN1 FunctionLoading the Upper Rack Adjusting the Upper BasketLoading the Lower Basket Cutlery Basket Are not suitableAre of limited suitability Daily Wash Cycle TableChange the Program Turning On the ApplianceForgot to Add a Dish? At the End of the Wash CycleFiltering System Filter assemblyCaring for the Dishwasher Cleaning the FilterPositioning the Appliance About Power ConnectionWater Outlet Water ConnectionExtension Hose Syphon ConnectionStart of Dishwasher Technical problems General problems Noise Before Calling for ServiceEscape. Begin unloading the dishwasher only once t Technical Information