Whirlpool 9400 CANCEL/DRAIN pad, Control panel lock-out feature, Adjusting the beeping sound

The CANCEL/DRAIN pad

The CANCEL/DRAIN pad allows you to cancel a cycle, to clear the signal lights or to

Immake a new selection. - 1

l

Press

CANCEL/DRAIN

while

the dish-

* Press

CANCEUDRAIN

again

to start a

washer

is washing

to

start

a 2 minute drain.

2 minute drain,

if there

is still

water in the

(If the

dishwasher

has not

been started or

dishwasher.

is not washing, it will

clear

the

display.)

NOTE:

A small

amount

of water

remaining

l

Press

CANCEUDRAIN

again

to stop the

in the

dishwasher is normal.

See

page 27.

drain.

Control panel lock-out feature

This feature lets you lock-out the function of the control pads (except to cancel or pause a cycle that is running). When the control panel is locked-out, the dishwasher cannot be started and a running cycle cannot be changed.

To use	the	lock-out	feature	PRESS	YOU SEE
1. Press	and	hold the OPTIONS and DELAY
pads until the CLEAN signal light flashes.

2.Release the pads. The CLEAN signal light will stop flashing.

To turn off the lock-out feature

1. Press and hold the OPTIONS and DELAY

Dads until the CLEAN sianal liaht turns on PRESSYOU SEE

1-

and stays on.

2.Release the pads. The CLEAN signal light will turn off.

Adjusting the beeping sound

Each time a control pad is pressed, a single “beep” sound is made. A double beep means one of the extra features was selected (such as control panel lock-out) or the wrong control pad was pressed.

To turn off the beep

1. Press and hold the OPTIONS pad until the	PRESS	YOU SEE
CLEAN signal light flashes.
2. Release the pad. The CLEAN signal light
will turn off.
NOTE: A power failure will reset this feature.
You will have to repeat the above steps.
To turn the beep back on
1. Press and hold the OPTIONS pad until the	PRESS	YOU SEE
CLEAN signal light turns on and stays on.
2. Release the pad. The CLEAN signat light
will turn off.