Audible signals
Audible signals are available to guide you when setting and using your oven. (A programming tone will sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will sound every 30 seconds after cooking is done to remind you that something has been left in the oven. A 4 beep sound signals the end of the Minute Timer function.) If you don’t hear a tone, it is because of incorrectly entered instructions or because the tones have been removed. For example, a tone wilt not sound if you touch a Number Pad before you touch a Command Pad.
To remove the programming tone:
*Open the door.
*Touch CANCEL twice, then touch START.
*Programming and reminder tones will be cancelled.
To replace the tones:
* Repeat the steps above.
NOTE: If your electrlcfty goes off, the audible signals above If you want to remove them agaln.
To remove all tones: l Open the door.
l Touch CANCEL twice, touch 0, then touch START. l All audible tones (including minute timer sig-
nal) will be cancelled.
NOTE: Do not remove all tones if you use the Minute Timer.
To replace the tones:
l Repeat the steps above.
wlii come back on. Repeat steps
Setting the clock
When the oven is first plugged in, one beep will sound and the Display shows 88:88. If the electric power ever goes off, the Display will again show all 8’s when the power comes back on.
You can cook without setting the clock, but the Display wilt be blank after cooking.
DO THIS... | THIS HAPPENS... |
2.Touch Number Pads tor the correct time of day.
The Display will show a “0”and the colon will start to flash. The first Number Pad must be touched wlthln 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.
The Display will show what numbers you touched in the order you touched them. This example shows 3:25.
The colon will stop flashing. The Clock is set.
3. | Touch START. | If you | have | touched in an incorrect | |
time, such as 12~55, “Err”will show on | |||||
|
| ||||
|
| the Display Touch CLOCK SETand | |||
|
| start | over. |
| |
NOTE: To reset the clock, touch CLOCK SET. The current time will show | on the | Display | |||
and the colon will flash. Contlnue to set the clock as shown above. |
|
| |||