Whirlpool MW3500XS manual Audible signals, Setting the clock

Page 6

Audible signals

Audible signals are available to guide you when setting and using your oven. (A programming tone will sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will sound every 30 seconds after cooking is done to remind you that something has been left in the oven. A

3 second tone signals the end of the Minute Timer function.] If you don’t hear a tone, it is because of incorrectly entered instructions or because the tones have been removed. For example, a tone will not sound if you touch a Number Pad before you touch a Command Pad.

To remove the programming tone and reminder To remove ail tones, except the Minute Timer

tone:signal:

l Open the door.

l Touch CANCEL twice, then touch START.

l Programming and reminder tones will be cancelled.

l

l

l

Open the door.

Touch CANCEL twice, touch 0, then touch START.

All audible tones (except Minute Timer signal) will be cancelled.

To replace

the tones:

To replace

the tones:

l Repeat

the

steps above.

l

Repeat the steps

above.

NOTE: it your

electricity goes off, the audible

signals

will come

back

on. Repeat steps

above if you want to remove them again.

 

 

 

 

Setting the clock

When the oven Is first plugged in, one beep will sound and the Display shows 88:88. If the electric power ever goes off, the Display will again show all B’s when the power comes back on.

You can cook without setting the clock, but the Display will be blank after cooking.

DO THIS...

THIS HAPPENS...

2.Touch Number Pads for the correct time of day.

3. Touch START.

The Display will show a “0”and the colon will start to flash. The tirst Number Pad must be touched within 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.

The Display will show what numbers you touched in the order you touched them. This example shows 3:25.

The colon will stop flashing. The Clock is set.

If you have touched in an incorrect time, such as 12:65, “Err”will show on the Display. Touch CLOCK SETand start over.

NOTE: To reset the clock, touch CLOCK SET.The current time and the colon will flash. Continue to set the clock as shown

will show on the Display above.

6

Image 6
Contents Model MW35OOXS Parts and features ContentsBefore you install your microwave oven Before you use your microwave ovenRead and follow Operating Safety Precautions starting on Grounding Instructions found onStallation Instructions found on Command pads Using your microwave ovenDigital display/clock and indicator lights Microwave oven controlsAudible signals Setting the clockCooking at high cook power Cooking in your microwave ovenChanging the cooking time Lower cook powersDQWI-I Percentage lo%, 50%, 80%, etcTouch a Number Pad for the Cook Power you want Touch Starit Count dQWI-IChanging cook power DefrostingChanging or adding defrost time Standing time or cooking automatically after defrostingAbout the Quick Defrost Cycle For cooking automatically after defrostingCooking in more than one cycle at one or more cook powers ‘... EliIOn next BEEP@P@BE@ Hints for cooking wifh more than one cyclePut cooked, hot food in oven and close door Using Keep WarmTo automatically follow another cycle Touch Keepwarm Touch StartMinute timer Touch Cook Power Touch 0 Number Pad Touch StartDelayed start Touch In the cooking ttme and Cook Power On nextTo double check sefflngr while the oven Is running Other operating hintsExtra Information To stop the oven while lt Is funningInstallation instructions Installing your microwave oven’i.~.‘~~.~~.~.C~.~.~ Observe all governing codes and ordinances Grounding InstructionsElectrical requirements ROpw5jCustom mounting your microwave oven Cleaning the microwave ovenCaring for your microwave oven Bi-level cookingHow your microwave oven works Operating safety precautions Contlnued on nextKeep door closed 0 turn oven oft General Information Before calling for assistanceIf you need assistance% If you need service If you have a problemPage WHIRl.Pool wu Pavfop