Whirlpool MH3184XPS manual Parts and Features, Electrical Requirements, Turntable, To Install

Page 5

Electrical Requirements

WARNING

Electrical Shock Hazard Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

PARTS AND FEATURES

This manual may cover several different models. The model you have purchased may have some or all of the features shown here. The appearance of your particular model may differ slightly from the illustrations in this manual.

A B

C

D

E F

GH I J K H

Observe all governing codes and ordinances. A 120 Volt, 60 Hz, AC only, 15- or 20-amp fused electrical supply is required. (A time-delay fuse or circuit breaker is recommended.) It is recommended that a separate circuit serving only this appliance be provided.

GROUNDING INSTRUCTIONS

A. Model and Serial Number Plate

B. Charcoal Filter

(behind Vent Grille)

C. Microwave Inlet Cover

D. Microwave Oven Light

E. Vent Grille

F. Control Panel

G. Metal Shielded Window

H. Cooktop Light

I. Cooking Guide Label

J. Grease Filters (shipped in

oven cavity)

K. Cooking Rack

Parts and Features not shown:

Turntable

For all cord connected appliances:

The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.

WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded.

Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven.

For a permanently connected appliance:

This appliance must be connected to a grounded, metallic, permanent wiring system, or an equipment grounding conductor should be run with the circuit conductors and connected to the equipment grounding terminal or lead on the appliance.

SAVE THESE INSTRUCTIONS

This device complies with Part 18 of the FCC Rules.

Turntable

A

B

C

D

A.Turntable

B.Hub

C.Support

D.Shaft

The turntable can rotate in either direction to help cook food more evenly. Do not operate the oven without the turntable in place. See “Assistance or Service” to reorder any of the parts.

To Install:

1.Remove tape from the hub.

2.Place the support on the oven cavity bottom.

3.Place the turntable on the support.

Fit the raised, curved lines in the center of the turntable bottom between the three spokes of the hub. The rollers on the support should fit inside the turntable bottom ridge.

5

Image 5
Contents Microwave Hood Combination Table of Contents Your safety and the safety of others are very important Microwave Oven SafetyImportant Safety Instructions To Install Parts and FeaturesElectrical Requirements TurntableCooking Rack Microwave Oven ControlDisplay Number CodesCancel Easy Minute FeatureTimer Demo ModeMicrowave Oven USE Food CharacteristicsCooking Guidelines Cookware and DinnerwareAluminum Foil and Metal Cooking PowerTo Test Cookware or Dinnerware for Microwave Use OK for UseSystem Cooking Preset CookingCooking Reheating BeverageCooking in Stages Warm Hold DefrostingTo Defrost manually To use the Defrost controlMicrowave Oven Care GeneralCleaningReplacing Filters To Replace Grease FiltersReplacing Oven Light TroubleshootingReplacing Cooktop Light Inthe U.S.A Assistance or ServiceReplacement Parts Second Through Fifth Year Limited Warranty on Magnetron Tube ONE-YEAR Full Warranty