Whirlpool GH9184XL manual Parts and Features, Electrical Requirements, Turntable, To Install

Page 5

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Observe all governing codes and ordinances. A 120 Volt, 60 Hz, AC only, 15- or 20-amp fused electrical supply is required. (A time-delay fuse or circuit breaker is recommended.) It is recommended that a separate circuit serving only this appliance be provided.

GROUNDING INSTRUCTIONS

For all cord connected appliances:

The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.

WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded.

Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven.

For a permanently connected appliance:

This appliance must be connected to a grounded, metallic, permanent wiring system, or an equipment grounding conductor should be run with the circuit conductors and connected to the equipment grounding terminal or lead on the appliance.

SAVE THESE INSTRUCTIONS

PARTS AND FEATURES

This manual may cover several different models. The model you have purchased may have some or all of the features shown here. The appearance of your particular model may differ slightly from the illustrations in this manual.

1

2 3

4

5

6

7

8

9

10

7

1.

Model and Serial Number

8.

Cooking Guide Label

 

Plate

9.

Charcoal and Grease Filters

2.

Microwave Inlet Cover

 

(shipped in oven cavity)

3.

Microwave Light

10.

Cooking Rack

4.

Vent Grille

 

 

5.

Control Panel

Parts and Features not shown:

6.

Metal Shielded Window

Turntable

7.

Cooktop Light

 

 

Turntable

1

2

3

4

1.Turntable

2.Hub

3.Support

4.Shaft

The turntable rotates in both directions to help cook food more evenly. Do not operate the microwave oven without the turntable in place. See “Assistance or Service” to reorder any of the parts.

To Install:

1.Remove tape from the hub.

2.Place the support on the oven cavity bottom.

3.Place the turntable on the support.

Fit the raised, curved lines in the center of the turntable bottom between the three spokes of the hub. The rollers on the support should fit inside the turntable bottom ridge.

5

Image 5
Contents Use & Care Guide Microwave Hood CombinationTable of Contents Your safety and the safety of others are very important Microwave Oven SafetyImportant Safety Instructions To Install Parts and FeaturesElectrical Requirements TurntableDesignedCooking Rack Microwave Oven ControlDisplay To Turn OffJET Cook Feature JET Start FeatureOff/Cancel TimerFoodCharacteristics Demo Learning ModeControlLock VentFanAluminum Foil and Metal CookingGuidelinesCookwareandDinnerware Cooking Cooking PowerInverter Microwave System Pre-SetCooking System CookingTo Use the 6th Sense System To Use Pre-Set CookingCooking in Stages BeverageReheating DefrostingMelt SoftenTo use the Defrost control To Defrost manuallyWarm Hold Kids MenuTo Melt To Use Kids MenuTo Replace General CleaningReplacing Filters Replacing Microwave Oven Light Replacing Cooktop LightTroubleshooting Replacement Parts If you need replacement partsInthe U.S.A For further assistancePage Whirlpool Corporation will not pay for ONE-YEAR Full Warranty