Audible signals
Audible signals are available to guide you when setting and using your oven [A programming tone will sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will sound every 30 seconds after cooking is done to remind you that something has been left in the oven. A
3 second tone signals the end of the Minute Timer function.] If you don’t hear a tone, it is because of incorrectly entered instructions or because the tones have been removed. For example, a tone will not sound if you touch a Number Pad before you touch a Command Pad.
To remove the programming tone and reminder tone:
l Open the door.
l Touch CANCEL twice, then touch START.
l Programming and reminder tones will be cancelled.
To replace the tones:
l Repeat the steps above.
NOTE: If your electricity goes off, the audible signals want to remove them again.
To remove all tones, except the Minute Timer signal:
l Open the door.
l Touch CANCEL twice, touch 0, then touch START.
l All audible tones (except Minute Timer signal] will be cancelled.
To replace the tones:
l Repeat the steps above.
will come back on. Repeat steps above if you
Setting the clock
When the oven is first plugged in, a tone sounds and the display shows 88:88. If the electric power ever goes off, the display will again show all 8’s when the power comes back on.
You can cook or use the Minute Timer without setting the clock, but the display will be blank after cooking, however AUTO STARTwill not work unless the clock is set.
DO THIS... | THIS HAPPENS... |
.
m
1. Touch CLOCK SET.
2.Touch Number Pads for the correct time of day.
3.Touch START.
The Display will show a “0”and the colon will start to flash. The first Number Pad must be touched within 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.
The Display will show what numbers you touched in the order you touched them This example shows 3:25.
The colon will stop flashing The Clock is set.
If you have touched in an incorrect time, such as12:65, “Err”will show on the Display. Touch CLOCK SETand start over.
NOTE: To | clock, | touch CLOCK | SET.The current | time | will show on the Display |
and the colon | will flash. | Continue to set | the clock as | shown | above. |