Whirlpool EV170NX, EV200FX, EVlZOFX Using the drain system On some models, Changing the light bulb

Using the drain system (On some models)

The freezer’s drain system consists of:

l

l

drain cap and sleeve (at the liner and cabinet bottom); and

drain hose.

The drain hose carries defrost water out of the freezer, and through the area behind the base grille, into a customer provided pan for disposal.

NOTE: The drain cap must be removed before defrosting the freezer, and replaced securely afterward.

Changing the light bulb

Electrical Shock Hazard

Before removing the light bulb, either turn Temperature Control to OFF and unplug the freezer, or disconnect the electricity leading to the freezer at the main power supply.

Shock and injury can occur if electricity remains connected.

To replace interior liQht:

1.Turn Temperature Control to OFF and disconnect freezer from power supply.

NOTE: Turning Temperature Control to OFF does not disconnect power to the freezer.

2.Remove the light shield by squeezing sides slightly and pulling out.

3.Replace bulb with 15-waft appliance bulb.

4.Replace light shield. Insert back tabs into slots and squeeze shield slightly to insert front tabs into slots.

5.Reconnect freezer to power supply and refer to Setting the temperature control” on page 7.

(On some models)

c

(I

Light shield

Using the key eject lock (On some models)

If your freezer is equipped with a lock, it can help reduce the hazard of child entrapment.

To lock or unlock the freezer, you must hold the key in the lock while turning. The lock is spring loaded, so the key cannot be left in the lock.

If the key is lost, contact your Whirlpool dealer for a replacement. Always give the complete model and serial number of your freezer when requesting a replacement key.

9