Install properly... | Remove | sales labels... |
|
|
| |||||
| Remove the Consumer Buy Guide label and any | |||||||||
| inside labels before ustng the freezer |
| ||||||||
| To remove | any | remaining | glue: |
|
| ||||
| 1 Rub briskly with thumb to make a ball, then | |||||||||
| remove |
|
|
|
|
|
|
|
| |
| OR |
|
|
|
|
|
|
|
|
|
| 2 Soak area with drshwashing detergent solution [I | |||||||||
| teaspoon | detergent | in | 1 quart | warm water] | be- | ||||
| fore removing glue as described In step 1 |
| ||||||||
| DO | NOT USE rubbing | alcohol | or | flammable | or | ||||
| toxic | solvents, | such | as | acetone, |
| gasoline, | car- | ||
| bon tetrachloride, |
| etc. |
| These | can | damage | the | ||
| material. |
|
|
|
|
|
|
|
| |
| NOTE: DO NOT REMOVE the Tech Sheet fas- | |||||||||
| tened | under | the freezer |
| at the | front. |
| |||
1 Check the strength of the floor It should hold the werght of a fully loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow 3 Inches (7 5 cm] air space on top of freezer for proper ventilation
4 Allow at least an Inch (2 5 cm] betweer the freezer conaenser, on the back of the unit. and the wall
5 Allow ‘: inch (1 25 cm) on each side of the freezer for ease of ir stallation
6 If the freezer IS to be against a wall you might want to leave extra space on the hinge side so the door can be opened wider
Level freezer...
so the door will stay open at any position
RaiseLower
This freezer has 2 threaded leveling legs that are shipped in a separate package.
4.Screw these legs all the way into bolt holes in the bottom front corners of the freezer
2.Slide the freezer into place.
3.Adjust front legs to level the freezer.
~ To lower front, turn legs counterclockwise.
4.Check with level.
5.After freezer is fully loaded, recheck wtth level.
Clean it ...
Clean your freezer before using It See cleaning InstructIons on page 7
Plug it in...
RetainiFg Clip
PowerFreezerPlug’
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only
this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extenslon cord.
Attach retaining clip over power cord plug from literature package inside the freezer.