Install properly... | Remove | sales labels... |
|
|
| ||||
| Remove the Consumer Buy Guide label and any | ||||||||
| inside labels before using the freezer |
| |||||||
| To remove | any | remaining | glue: |
|
|
| ||
| 1 Rub briskly with thumb to make a ball, then | ||||||||
| remove |
|
|
|
|
|
|
| |
| OR |
|
|
|
|
|
|
|
|
| 2 Soak area with dishwashlng detergent solution (1 | ||||||||
| teaspoon detergent in 1 quart warm water] be- | ||||||||
| fore removing glue as described in step 1 |
| |||||||
| DO | NOT USE rubbing | alcohol | or | flammable | or | |||
| toxic | solvents, | such as | acetone, |
| gasoline, | car- | ||
| bon tetrachloride, | etc. | These | can | damage | the | |||
| material. |
|
|
|
|
|
|
| |
| NOTE: DO NOT REMOVE the Tech Sheet fas- | ||||||||
| tened | under | the freezer | at | the | front. |
| ||
1 Check the strength of the floor It should hold the weight of a fully loaded freezer.
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3Allow 3 Inches (7 5 cm] air space on top of freezer for proper ventllatlon.
4.Allow at least an Inch (2 5 cm] between the freezer condenser, on the back of the unit. and the wall
5.Allow 1: inch [I 25 cm] on each side of the freezer for ease of lnstallatlon
6 If the freezer IS to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider
mem.ra-,,.I
Level freezer.. .
so the door will stay open at any position
Leveli
This freezer has 2 threaded leveling legs that are shipped in a separate package.
1.Screw these legs all the way into bolt holes in the bottom front corners of the freezer.
2.Slide the freezer into place.
3.Adjust front legs to level the freezer.
~ To lower front, turn legs counterclockwise.
4.Check with level.
5.After freezer is fully loaded, recheck with level.
Clean it ...
Clean your freezer before using it See cleaning instructions on page 7
Plug it in...
Freezer | grounding | plug |
Power Cord |
Recommended Grounding Method
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrlcal supply IS rem
qulred It is recommended that a separate circuit serving only this appliance be provided
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electribal require- ments and grounding Instruction sheet in your liter- ature package
4