Whirlpool ET1 8MK Install properly, Level refrigerator-freezer, Remove sales labels, Clean it

Install properly.. .

1Allow %” (.2 cm] space on each side and at top for ease of Installation.

2 The refrigerator bock can be flush against the

Wd

3If the refrrgerator ISto beagarnst a wall, you might want to leave enough space so the door can be obened wrder

Level refrigerator-freezer.. .

Right to Raise;

Left to Lower

I. Remove base grille [see page 8)

2.To raise front, turn each screw to the right

3.To lower front, turn each screw to the left.

4.Check with level.

Remove sales labels.. .

Remove the Consumer Buy Guide label and other inside labels before using the refrigerator Any glue left can be taken off wrth rubbrng alcohol

Do not remove the label giving operating in-

structions for the Refrigerator and Freezer COn-

trols or the Tech Sheet fastened under the

refrigerator at the front.

Clean it.. .

I

Clean your refrrgerator before using It. See clean rng InstructIons on page 8

Plug it in...

3-prong

grounding type wall receptacle

Refrigerator

Power Cord

RECOMMENDEDGROUNDINGMETHOD

A 115 Volt, 60 Hz, AC only, 15 or 20 ampere fused electrical supply is requrred It ISrecommended that CI separate circurt serving only this appliance be provided.

Do not use an extensron cord. Use a receptacle which cannot be turned off with a switch or pull chain. See individual electrrcal requirements and

grounding instruction sheet In your literature package

4