Using your freezer
Setting the Cold Control...
To start, turn control to the middle of the dial. This setting will mahtain zero zone temperatures under normal operating conditions.
i’
Adjusting Cold Control...
l Turn control to higher number for colder temperatures.
l Turn to lower number for less cold temperatures.
Coolinlg Freezer First...
l Allow freezer to cool 6 to 8 hours before filling with frozen food.
l Let it l::ool overnight before adding large amounx of unfrozen food.
lFrost WIII form on the shelves. It will form first and be hecvier on the top shelves.
Note: Wpen freezer is first started the compressor will run constantly until the cabinet is cooled. It may tak(l up to 6 to 8 hours or longer, depending
on room temperature and the number of times the freeze:?r door is opened.
Afterttle cabinet is cooled the compressor will turn on ilnd off as needed to keep freezer at proper 1c>mperature.
The Power Saving Control...
operates electric heaters. These heaters help prevent noisture from forming on the outside of the freezerwhen humidity is high
lUse thf:bOFF setting when humidity is low to save electril.:ity.
l Use O’\l only if moisture forms on outside of freeze1
The Key Eject lock...
can help reduce the hazard of child entrapment.
To lock or unlock the freezer you must hold the key in the lock while turning. The lock is spring loaded so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL dealer
for a replacement. Always give the complete model and serial number of your freezer when
requesting a replacement key.
Bottom Trivet...
To remove.
l Lift up, then pull out.
To replace.
lSet in bottom of freezer.
lPush into place.
Ii Lift up
Then out
3