Before you plug it in
Before using your freezer, you are personally
responsible for making sure that it...
l is installed and leveled on a floor that will hold the weight, and in an area suitable for its size and use.
l is connected only to the right kind of outlet, with the right electric supply and grounding (see below).
l is used only for jobs expected of home freezers.
l is not near an oven, radiator or other heat source.
Install Properly...
Allow room to ooen lid | I | I | I |
w | |||
| 2 inches | at | back |
| Iwl, |
|
|
1 | 10 |
|
|
3 inches | 3 inches |
|
|
l is properly maintained.
l is in a dry sheltered area
l is used in an area where the room tempera- ture will not exceed
l is not run where there are explosive fumes.
l is not used by children or others who may not understand how it should be used.
l is not loaded with food before it has time to get properly cold.
Remove Sales label...
Remove the Consumer Buy Guide label before using the freezer. Remove any left over glue with rubbing alcohol.
Note: DO NOT REMOVE the Care and Ser- vice label on the inside lid. This permanent
label provides immediate information should it be needed. Do not remove Tech
Sheet permanently attached to back of cabinet.
Clean It...
Clean your freezer before using it. See clean- ing instructions on page 4.
1.Check the strength of the floor. It should hold weight of fully loaded freezer.
2.Allow at least 3 inches (7.5 cm) air space on all sides of freezer and 2 inches (5 cm) at back. Leave room at top for lid to open all the way.
3.It should not be necessary to remove the lid
during installation. If, for any reason, the hinges
need adjustment, see your authorized WHIRLPOOL dealer.
4.Do not cover the freezer with items such as blankets, sheets, tablecloths, etc.
Defrost Drain Cover...
Installing Defrost Drain Cover:
1.Remove cover from literature package.
2.Check drawing on page one for placement.
3.Install cover.
Plug It In...
level Chest Freezer.. .
from end to end and front to back so that the lid will seal properly
Check with level
2~
Recommended Grounding Method
A 120 Volt, 60 Hz., AC only, 15 ampere fused electrical supply is required. It is recommended that a separate circuit serving only this appli-
ance be provided. The receptacle should not be controlled by a wall switch or pull chain.
Attach retaining clip over power cord plug
from the literature package inside your freezer Do not use an extension cord.