Before you pluc1 it, Remove Sales label

Before you pluc1 it in

Before using your freezer, you are personally responsible for making sure that it...

l is installed and leveled on a floor that will hold the weight, and in an area suitable for its size and use.

l is connected only to the right kind of outlet, with the right electric supply and grounding (see page 3).

l is used only for jobs expected of home freezers.

l is not near an oven, radiator or other heat source.

. is properly maintained.

. is in a dry sheltered area.

. is used in an area where the room tempera- ture will not exceed 110 F,(43 3 C).

. is not run where there are explosive fumes.

. is not used by children or others who may not understand how it should be used.

. is not loaded with food before it has time to get properly cold.

Install Properly..	.	level	Chest Freezer.. .
		from end to end and front to back so that the Ird
		will seal	properly.

Check with level

1.Check the strength of the floor. It should hold weight of fully loaded freezer.

2.Allow at least 3 inches (7.5 cm) air space on all sides of freezer and 2 inches (5 cm) at back. Leave room at top for lid to open all the way.

3.It should not be necessary to remove the lid

during installation. If, for any reason, the hinges

need adjustment, see your authorized WHIRLPOOL dealer.

4.Do not cover the freezer with items such as blankets, sheets, tablecloths, etc.

Remove the Consumer Buy Guide label before using the freezer. Remove any left over glue with rubbing alcohol.

Note: DO NOT REMOVE the Care and Ser- vice label on the inside lid. This permanent

label provides immediate information should it be needed. Do not remove Tech

Sheet permanently attached to inside of service panel.

Clean your freezer before using it See clean- ing instructions on page 4.

Installing Defrost Drain Cover:

1.Remove cover from literature package.

2.Check drawing on page one for placement

3.Install cover.