Whirlpool 9762363A manual Bakeware, Oven Vent, Baking and Roasting, Meat Thermometer

Bakeware

The bakeware material affects cooking results. Follow manufacturer’s recommendations and use the bakeware size recommended in the recipe. Use the following chart as a guide.

BAKEWARE/	RECOMMENDATIONS
RESULTS
Light colored	■ Use temperature and time
aluminum	recommended in recipe.

■Light golden crusts

■Even browning

Oven Vent

A

A. Oven vent

The oven vent releases hot air and moisture from the oven, and should not be blocked or covered. Blocking or covering the oven vent will cause poor air circulation, affecting cooking and

Dark aluminum and other bakeware with dark, dull and/or nonstick finish

■Brown, crisp crusts

■May need to reduce baking temperatures 25°F (15°C).

■Use suggested baking time.

■For pies, breads and casseroles, use temperature recommended in recipe.

■Place rack in center of oven.

cleaning results. Do not set plastics, paper or other items that could melt or burn near the oven vent.

Baking and Roasting

ACCUBAKE® DUO SYSTEM® Temperature Management (on some models)

Insulated cookie	■	Place in the bottom third of oven.
sheets or baking	■	May need to increase baking time.
pans

■Little or no bottom browning

Stainless steel ■ May need to increase baking time.

■Light, golden crusts

■Uneven browning

Stoneware/Baking		■ Follow manufacturer’s
stone		instructions.
■	Crisp crusts
Ovenproof		■ May need to reduce baking
glassware, ceramic		temperatures 25°F (15°C).
glass or ceramic
■	Brown, crisp
	crusts

Meat Thermometer

On models without a temperature probe, use a meat thermometer to determine doneness of meat, poultry and fish. The internal temperature, not appearance, should be used to determine doneness. A meat thermometer is not supplied with this appliance.

■Insert the thermometer into the center of the thickest portion of the meat or inner thigh or breast of poultry. The tip of the thermometer should not touch fat, bone or gristle.

■After reading the thermometer once, push it into the meat ½" (1.3 cm) more and read again. If the temperature drops, cook the meat or poultry longer.

■Check all meat, poultry and fish in 2 or 3 different places.

The ACCUBAKE® DUO SYSTEM® temperature management technology uses two sensors to maintain even temperatures.

The two temperature sensors independently control the bake and broil burners for optimal cooking results. The bake and broil cycle on and off in intervals. This feature is automatically activated when the oven is in use.

Before baking and roasting, position racks according to the

“Positioning Racks and Bakeware” section. When roasting, it is not necessary to wait for the oven preheat conditioning time to end before putting food in unless recommended in the recipe.

To Bake or Roast:

1.Press BAKE.

2.Press TEMP or TEMP/TIME “up” or “down” arrow pad to set a temperature other than 350°F (175°C) in 5°F (3°C) amounts. The bake range can be set between 170°F and 500°F (75°C and 260°C).

When the oven temperature is greater than 170°F (77°C), no preheat conditioning time will be shown in the display. The preheat conditioning time will not change if the temperature is reset before the countdown time ends.

3.Press START or START/ENTER. The temperature can be changed after this step. The start pad does not need to be pressed again.

If baking and roasting while the minute timer is counting down, the set temperature can be seen for 5 seconds by pressing BAKE.

4.Press CANCEL or OFF/CANCEL when finished.

Preheating

After the start pad is pressed, the oven will enter a timed preheat conditioning. “PrE” (on some models) and the countdown time will appear on the display. When the preheat conditioning time ends, a tone will sound and the selected temperature will appear on the display.

Preheat temperatures are affected by varying factors such as room temperature and peak energy usage times. It is normal for the temperature showing on the display and the actual oven temperature to differ due to the cycling of the elements.

Waiting an additional 10 minutes, after the preheat conditioning time ends, to put food in the oven is suggested when baking foods with leavening ingredients, such as yeast, baking powder, baking soda and eggs.

10