Broan 784 manual Read and Save These Instructions, Cleaning & Maintenance, Operation, Warranty

Page 1

MODEL 784

CEILING VENTILATOR

MODEL 784

Page 1

READ AND SAVE THESE INSTRUCTIONS

WARNING

TO REDUCETHE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1.Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty.

2.Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

3.Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards.

4.Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equip- ment to prevent backdrafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authori- ties.

5.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

6.Ducted fans must always be vented to the outdoors.

7.If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application and be connected to a GFCI (Ground Fault Circuit Interrupter) - protected branch circuit.

8.Never place a switch where it can be reached from a tub or shower.

9.This unit must be grounded.

CAUTION !

1.For general ventilating use only. Do not use to exhaust hazard- ous or explosive materials and vapors.

2.To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit.

3.Please read specification label on product for further informa- tion and requirements.

CLEANING & MAINTENANCE

For quiet and efficient operation, long life, and attractive appear- ance - lower or remove grille and vacuum interior of unit with the dusting brush attachment.

The motor is permanently lubricated and never needs oiling. If the motor bearings are making excessive or unusual noises, replace the blower assembly (includes motor and impeller).

TO CLEAN GRILLE:

CAUTION: Grille can be cleaned with mild, soapy water (use a mild detergent, such as dishwashing liquid) and dried with a soft cloth. DO NOT USE ABRASIVE CLOTH, STEEL WOOL PADS,

OR SCOURING POWDERS.

TO CLEAN FAN ASSEMBLY:

Unplug fan assembly. To remove motor plate: Find the single tab on the motor plate (located next to the receptacle). Push up near motor plate tab while pushing out on side of housing. Or insert a straight-blade screwdriver into slot in housing (next to tab) and twist screwdriver. Gently vacuum fan, motor and interior of hous- ing. METAL AND ELECTRICAL PARTS SHOULD NEVER BE IMMERSED IN WATER.

OPERATION

Use an on/off switch or speed control to operate this ventilator. See “Connect Wiring” for details. Use of speed controls other than the Broan Models 78V and 78W may cause a motor humming noise.

WARRANTY

BROAN-NUTONE ONE YEAR LIMITED WARRANTY

Broan-NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one year from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANT- ABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

During this one-year period, Broan-NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.

THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS, TUBES, HALOGEN AND INCANDESCENT BULBS, FUSES, FILTERS, DUCTS, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR DUCTING. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by Broan- NuTone), faulty installation or installation contrary to recommended installation instruc- tions.

The duration of any implied warranty is limited to the one-year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.

BROAN-NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT BROAN-NUTONE’S OP- TION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. BROAN-NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUEN- TIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation of inciden- tal or consequential damages, so the above limitation or exclusion may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.

To qualify for warranty service, you must (a) notify Broan-NuTone at the address or tele- phone number below, (b) give the model number and part identification and (c) describe the nature of any defect in the product or part. At the time of requesting warranty service, you must present evidence of the original purchase date.

Broan-NuTone LLC, 926 W. State Street, Hartford, Wisconsin 53027 www.broan.com 800-558-1711

Installer: Leave this manual with the homeowner.

Register your product online at: www.broan.com/register

Image 1
Contents Warranty Cleaning & MaintenanceRead and Save These Instructions OperationHousing hung with wires 3-point mount Typical Installations2x6 or larger Requires additional framing for mounting tabsInstall the Ductwork Install the HousingNEW Construction Existing ConstructionService Parts Connect the WiringAttach the Grille DescriptionLEA Y Conserve Estas Instrucciones 2x6 o más grande Instalaciones TípicasCubierta montada con cables Montaje de tres puntos Cubierta Instalación DE LAInstalación DEL Sistema DE ConductosConexión DE LA Rejilla Conexión EléctricaPiezas DE Servicio NO. Clave NO.PIEZA DescripciónAvertissement Lire CES Directives ET LES ConserverNettoyage ET Entretien FonctionnementDe 2X6 ou plus Installations TypeLes brides de montage exigent un cadre supplémentaire Boîtier suspendu à des fils de fer en 3 pointsConstruction Neuve Bâtisse Déjà Construite Installation DU BoîtierVeuillez Noter Pièces DE Rechange Raccord DU CâblageFixation DE LA Grille Repère DE Pièce Description

784 specifications

The Broan 784 ventilation fan is a standout choice for those seeking an effective and stylish solution for home air quality. Designed with a sleek appearance, this model seamlessly integrates into various bathroom designs while delivering exceptional performance. One of its main features is its powerful 100 CFM ventilation capacity, which effectively removes moisture and odors, ensuring a fresh and comfortable environment.

The Broan 784 is equipped with a quiet operation technology, producing just 1.5 sones at full speed. This low noise level makes it an excellent choice for bathrooms, as it maintains a tranquil atmosphere while efficiently managing air circulation. Homeowners can enjoy the benefits of its powerful airflow without the disruptive sounds typically associated with ventilation fans.

Another characteristic of the Broan 784 is its energy efficiency. This model not only helps maintain optimal air quality but does so while utilizing minimal power. With an ENERGY STAR certification, it promotes lower energy consumption, benefiting both the environment and your utility bills.

In terms of installation, the Broan 784 is designed for easy mounting, featuring a compact design that allows for easy integration into existing spaces. The fan's housing is constructed from high-quality materials, ensuring durability and longevity. Additionally, it comes with a built-in damper that prevents backdrafts, further enhancing its efficiency.

The Broan 784 also includes a stylish white grille that easily blends into any bathroom decor. It offers an aesthetic appeal without compromising on functionality.

Moreover, users appreciate the integrated light feature of the Broan 784, which adds versatility to the fan. This built-in light provides adequate illumination, making it a convenient choice for bathrooms that require additional lighting. The ability to serve dual purposes, as both a ventilation fan and a light source, adds significant value to this model.

In summary, the Broan 784 ventilation fan is an exceptional choice for homeowners looking for a combination of style, efficiency, and functionality. With its powerful airflow, quiet operation, energy-efficient design, and integrated lighting, it stands out as an ideal solution for enhancing indoor air quality and overall bathroom experience.