CDA 3L9 manual Replacing the main halogen down lights, Replacing the ambient lighting side lamps

Page 6

Replacing the main halogen down lights:

1.Lower the lamp panel (G) and unscrew the 4 lamp housing fixing screws (F) to access the bulb covers.

2.Carefully prise off the bulb covers using a small screwdriver and refit the new bulb taking care not

to touch the glass of the bulb (Fingerprints will lead to premature failure of the bulb)

Replacing the ambient lighting side lamps

In normal use, the LED ambient lighting should not require replacement and is intended to last the lifetime of the product. In the event that these lights fail to operate, please contact our service department for repair.

	4
	B
	C
F	F
F
G	G
	F
	F
Fig. 10

Image 6

Contents 3L9 Extractors Appliance information CE Declarations of ConformityPlease note Using your Extractor Synchronising your remote with the extractor Using your Remote ControlTo change the battery To set the motor speedCleaning the grease filter Care and MaintenanceCleaning Changing the charcoal filterReplacing the main halogen down lights Replacing the ambient lighting side lamps650mm InstallationMounting The Extractor Min 3mmWhen used with a CDA hob, the extractor is required = C 350+650+B3mm Be levelled using the adjustment system FigPlate using the 2 supplied screws D and proceed to Loosen the body fixing screws G in byInstallation Troubleshooting Mains Electricity ConnectionElectrical Information Customer Care Department 01949 862