Capresso 444, MT600, MG600, 445 warranty Equipment, Preparing the Coffee Maker 2a. Before First Use

Page 7

1. Equipment

The Capresso MG600/MT600 comes complete with: • Stainless Steel Thermal Carafe with Lid (MT600), Glass Carafe with Lid (MG600)

GoldTone Filter (inserted in removable Filter Holder) • Measuring Scoop • Charcoal Filter with Charcoal Filter Holder • Instruction Book and Mail Order Form

2.Preparing the Coffee Maker 2a. Before First Use

After unpacking your coffee maker clean all the loose parts with warm water and make yourself familiar with the different functions. After reading these instructions, let some water run through the coffee maker to clean all internal parts.

2b. The Display / Setting the Clock and Timer

When you plug in the coffee maker the display will illuminate for about 30 seconds and will flash “12:00”.

All indicator lights will be off.

2c. To Set the Current Time (Fig. 2) Push and hold the hour button. The hours will advance. The little dot on the left upper side (indicating AM) changes to a left lower dot (indicating PM). When the correct hour shows up release the button and push and hold the minute button to set the minutes. Attention: You must change the clock when the time changes (Standard Time, Daylight Savings Time).

2d. To Set an Auto-On Time:

If you want the coffee maker to start brewing at a preset time automatically, first push the program button (Fig. 2, P). The display shows "12:00". Immediately start pushing the hour and minute buttons as described above until the desired time shows up. Within a few seconds the display will revert to the actual time.

To check the programmed time just

push the program button. The display shows the programmed time and will switch back to the actual time.

To change the programmed time, push the program button and repeat as described above.

Attention: Flashing Display!

If you unplug the coffee maker for more than 10 seconds or if you have a power failure, you will lose the current time and program settings. The flashing display indicates that you must reset the current and programmed time.

3.The Charcoal Filter Indicator To start the electronic charcoal indicator, push the blue filter button (Fig. 2, Q). The green indicator light for the charcoal filter will turn on.

If you use spring water, bottled water or distilled water and make coffee right away, it is not necessary to use the charcoal filter. Push the blue Filter Button (Fig. 2, Q) and the green filter indicator light will turn off.

Attention: Spring water and distilled water might attract impurities when sitting in the water container overnight. The charcoal filter will remove most of these impurities since the water will be filtered just before entering the heating element.

3a. Using the Charcoal Water Filter Most tap water is treated with chlorine. The charcoal filter removes up to 82% of the chlorine and other impurities found in tap water, improving the taste of water substantially.

The charcoal cartridge sits in the charcoal holder (see Fig. 4). The charcoal holder is already inserted into the water container.

To activate the charcoal cartridge pour four cups of water into the water container and let it sit for approx. 3 minutes. Then turn the machine on and let the water brew into the carafe (see chapter 5e). Discard the water.

7

Image 7
Contents MG600 MT600 Important Safeguards Welcome and Thank You How To Contact Jura-CapressoContents 150 Lift up Equipment 2b. The Display / Setting the Clock and TimerPreparing the Coffee Maker 2a. Before First Use Proper Sequence for Making Coffee 5c. How Much Coffee? 5b. Using Filter PaperMaking Coffee Filling the Water TankHandling of the Stainless Steel Thermal Carafe Cleaning the Coffee MakerGround coffee is flowing over the GoldTone Filter Cleaning the Stainless Steel Thermal Carafe10a. How to Decalcify with White Vinegar DecalcifyingCustomer Service This warranty does not cover Limited One Year WarrantyPage Capresso Product Registration