Capresso MT500 Plus, 440 manual Equipment, 2b. The Display / Setting the Clock and Timer

1. Equipment

The Capresso MT500 comes complete with: • Stainless Steel Thermal Carafe with Lid • GoldTone Filter (inserted in removable Filter Holder) • Measuring Scoop • Charcoal Filter with Charcoal Filter Holder • Instruction Book and Mail Order Form

2.Preparing the MT500 2a. Before First Use After unpacking your MT500

clean all the loose parts with warm water and make yourself familiar with the different functions. After reading these instructions, let some water run through the coffee maker to clean all internal parts.

2b. The Display / Setting the Clock and Timer

When you plug in the MT500 the orange display will flash "º 12:00" and the green indicator light for the char- coal filter will be on. All other indicator lights are off.

2c. To Set the Current Time (Fig. 2) Push and hold the hour button. The little dot on the left upper side (indi- cating AM) changes to a left lower dot (indicating PM). When the correct hour shows up release the button and push and hold the minute button to set the minutes.

Attention: You must change the clock when the time changes (Standard Time, Daylight Savings Time).

2d. To Set an Auto-On Time:

If you want the MT500 to start brew- ing at a preset time automatically, first push the program button (Fig. 2, P). The display shows "º12:00". Immediately start pushing the hour and minute buttons as described above until the desired time shows up. Within a few seconds the display will revert to the actual time.

To check the programmed time just

push the program button. The display shows the programmed time and will switch back to the actual time.

To change the programmed time, push the program button and repeat as described above.

Attention: Flashing LED Display! If you unplug the MT500 for more than 10 seconds or if you have a power failure, you will lose the current time and program settings. The flash- ing LED display indicates that you have to reset the current and pro- grammed time.

3.The Charcoal Filter Indicator When you plug in the MT500

the green indicator light for the char- coal filter will be on (Fig 2, Q).

If you use spring water, bottled water or distilled water and make coffee right away, it is not necessary to use the charcoal filter. Push the blue Filter Button (Fig. 2, Q) and the green filter indicator light will turn off.

Attention: Spring water and distilled water might attract impurities when sitting in the water container overnight. The charcoal filter will remove most of these impurities since the water will be filtered just before entering the heating element.

3a. Using the Charcoal Water Filter Most tap water is treated with chlo- rine. The charcoal filter removes up to 82% of the chlorine and other impuri- ties found in tap water, improving the taste of water substantially.

The charcoal cartridge sits in the charcoal holder (see Fig. 4). The char- coal holder is already inserted into the water container.

To activate the charcoal cartridge pour four cups of water into the water container and let it sit for approx. 3 minutes. Then turn the machine on and let the water brew into the carafe (see chapter 5e). Discard the water.

7