DCS 221712 manual Installation

		INSTALLATION
3.	Assembly of the 10” Transition.
	The transition supplied with the hood mounts to the top
	of the hood, Figure 5.			Duct
	a. Place the transition piece over the hood exhaust			Transition
	and secure with 4 screws provided.
	b. Duct tape connection between transition and
	hood.		f
		o
		To
		p		d
			o
		o
	c. Remove tape holding damper.	H
4.	Check that the screws on bottom of chimney structure
	are partially screwed into place; these will serve to hang	FIG.5
	and fix the canopy.
5.	If already mounted in place remove all grease filters.
6.	Back out the hanging screws on the bottom of the
	chimney structure to 1/4” gap.
	Lift the canopy up to the chimney support .
	Carefully align the canopy keyhole to the screws on the
	chimney support.
	Slide the hood to engage the keyhole slots. See Fig. 6.
7.	Tighten screws securely (from inside the canopy). Fix	FIG.6
	canopy to structure with 4 screws from inside the
	canopy. See Fig. 7.
8.	Make final angular adjustment to unit at ceiling if necessary, then finish installation adding two
	fixing screws. See Fig. 8.

Screw

FIG.7

additional

fixing screw

FIG.8

10