Installing your Cooker Hood
Fitting the Chimney Stack:
To fit the upper chimney section, first expand the chimney slightly to allow it to be fitted over the wall brackets. Then secure the upper section using the two self tapping screws provided.
The lower chimney section should be located following instructions on page 6, ensuring that the lugs in the base of the chimney are seated into the two recesses on either side of the canopy.
Fig.10
ATTENTION: Should the lower chimney section subsequently be removed, the two securing lugs in the top canopy must be released.
Once the chimney stack has been installed, fit the two venting grilles into the apertures located on either side of the upper chimney stack. The grilles are marked with two arrows and should be fitted with one arrow pointing upwards and the other towards the front.
When used in the recirculation mode, ensure the grilles are properly secured to the recirculation spigot.
8