TOA Electronics HB-1 operating instructions General Description, Features, Handling Precautions

Page 3

2. GENERAL DESCRIPTION

The TOA HB-1 is a high-power, wall/ceiling-mounted sub-woofer system employing a 20 cm speaker unit. Although small in size, the HB-1 provides clear super-low frequency sound reproduction thanks to its Acoustic Super Woofer enclosure construction.

3. FEATURES

A large, 110 mm-diameter ferrite magnet, a long, 35 mm-diameter voice coil, an aluminum bobbin, and a rubber roll edge combine to permit large voice coil movement at high power input.

The Acoustic Super Woofer system enclosure creates an acoustic band-pass filter that reproduces super- low frequencies down to 45 Hz and realizes slow-slope phase characteristics.

The enclosure is 103 mm in depth from the mounting surface, and suitable for mounting in a wall with two- by-four construction.

Rotating lock tabs permit the speaker to be temporarily fixed during installation. Also, the speaker has provisions for wire or bolt suspension.

The speaker can be converted to high-impedance applications with the addition of the optional MT-S0601 matching transformer.

4. HANDLING PRECAUTIONS

No anti-magnetic provisions have been made for the HB-1 speaker. Therefore, take care to keep the unit sufficiently away from televisions, monitors or computer-related equipment.

5. NOMENCLATURE AND DIMENSIONS

[Front]

[Side]

[Rear]

Front grille

Speaker

544

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

430

 

 

32

 

103

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

[Bottom]

Detachable input connector

(Unit: mm)

Mounting bracket (standard accessory)

Hook clip

520

352

3

Image 3
Contents Operating Instructions Table of ContentsWhen the Unit is in Use Safety PrecautionsSafety Symbol and Message Conventions When Installing the UnitGeneral Description FeaturesHandling Precautions Nomenclature and DimensionsFront Vertical cross-sectional Horizontal cross-sectional InstallationContents Flush Wall or Ceiling MountingWhen mounting the bracket to the ceiling panel When mounting the bracket to two-by-four constructionSingle connection Bridge connection Terminals to use with a screwdriverSurface Suspending the unit Bolt suspension Wire Suspension Front grille installationSuspending the Unit in the Ceiling Matching Transformer Installation Recommended Filters for the HB-1 Level balance adjustmentPolarity adjustment Crossover Connections with a FULL-RANGE SpeakerHigh-impedance amplifier low-frequency threshold Matching transformer low-frequency thresholdAccessories Specifications