Best UP27E, UP271 manual Remove the Grease Drip Rail, Remove the PAN, Prepare the Cabinet

5. REMOVE THE GREASE DRIP RAIL

Remove tape on grease drip rail. Lift out grease drip rail and set aside.

HD0212

6. REMOVE THE PAN

Using a Phillips no. 2 screwdriver, remove the screws retaining the pan (shaded parts on illustration below) to the hood. Remove the pan and set aside.

NOTE: There are 2 screw models for UP27I pan retaining screws; the flat end type (A) (n°. 8 x 3/8”) are shorter and located near the front of the hood and the pointed end ones (B) (n°. 6 x 1/2”) are longer located in the middle of the hood. UP27E pan retaining screws are all the same.

UP27I RETAINING SCREWS LOCATION				UP27E RETAINING SCREWS LOCATION
A	A	A	A	A	A	A	A
B	B
	B
A: no. 8 x 3/8”		B: no. 6 x 1/2”			A: no. 8 x 3/8”
HD0207

7. PREPARE THE CABINET

For cabinets with recessed bottom, attach two wood filler strips cut to length (not included), on each side, as shown below. See table below for wood filler strips location.

HOOD	CENTER OF WOOD
WIDTHS	STRIP LOCATION (A)
30”	13 3⁄8”
36”	16 3⁄8”
42”	19 3⁄8”
48”	22 3⁄8”

	C
	L
A	A
HD0208

- 7 -