www.zephyronline.com
Installation - Internal Blower
NOTE! The device in this version (with internal suction motor) is equipped for rear discharge of exhaust air. However, if required, it is possible to have the exhaust air discharged from the top. This can be accomplished by following the steps indicated in the following paragraphs; upon reaching step 7, the motor plate must not be rotated, there- fore skip steps 8 and 9 and proceed from step 10 directly.
The following instructions are for installing the internal blower. CAUTION: To reduce the risk of fire and electric shock, install this range- hood only with internal blower models
For external and
1. Open the front panel, Fig.1
NOTE! Open the front panel while holding it by its external sides, as shown in Fig.1, and keep at a suitable distance to avoid impacting it.
2. Remove the Decorative Mesh Filters.
3. Loosen the two screws inside the hood that fasten the canopy. Fig.2
4. Slide the top cover off by lifting it. Fig.3
5. Close the front panel while holding it by its exter- nal sides until it shuts.
- 10 -