NuTone WS130AA DAMPER/DUCT Connector, Wiring Cover, AIR Chute, Baffle, Slots, Tabs Support FIN

ALLURE™ WS1 SERIES RANGE HOOD

PREPARE THE HOOD

3 Remove

Damper/Duct Connector from inside the hood. Set connec- tor aside - with mounting screws and parts bag.

DAMPER/DUCT

CONNECTOR

4	Remove Wir-
	ing Cover from
	inside the hood.
	Set cover and
	mounting screw
	aside.

WIRING

COVER

5	Remove either
	top or back wir-
	ing knockout and
	install approved
	Electrical Cable
	Clamp.

Page 3

PREPARE THE HOOD

AIR CHUTE

7	Remove Air
	Chute - held in
	place with one
	(1) screw.

NOTE: Be care- ful not to discon- nect any wires.

8	Remove Baffle
	from air chute.

	BAFFLE
BAFFLE
	

ELECTRICAL CABLE CLAMP

Non-Ducted Installation - Skip to “Connect
Wiring” section.	(3) #8 SCREWS	LIGHT
		PANEL
The following
Steps (6 thru	(2) #8 SCREWS
13) are for
DUCTED
INSTALLATION
ONLY.

6 Remove Light Panel - held in place with (3) #8 screws and (2) #8 screws. Disconnect light assembly wire harness

(white connector).

9

10



Rotate baffle. Re- insert baffle into air chute (as shown) so that baffle tabs fit all the way into slots in air chute. An audible “click” will be heard when fully installed. This will close off the air flow through the non-ducted slots on top of hood.

SLOTS



Re-install air chute, re-connect wire harness, and replace light panel.

NOTE: Be careful not to trap wires between support fin and light panel.

TABS



SUPPORT FIN