INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
8" Pull-Chain Model 8010
10"
IMPORTANT SAFETY INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE. ELECTRIC SHOCK,
OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.
B. Before servicing or cleaning unit, switch power off at service panel and lock service panel to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.
CAUTION: |
|
For general ventilating use only. Do not use to exhaust hazardous or |
|
explosive materials and vapors. | FIGURE 1 |
|
INSTALLATION INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
A. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including
B. Sufficient air is needed for proper combusition and exhausting of gases
through the flue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating equipment manufacturer's guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.
C. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
D. Ducted fans must always be vented to the outdoors.
E. If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application.
F. NEVER place a switch where it can be reached from a tub or shower.
•WARNING: To reduce the risk of shock, disconnect power before servicing.
•CAUTION: To reduce risk of fire and to properly exhaust air, be sure to vent air outside. Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces or garages.
•WARNING: To reduce the risk of fire or electric shock, do not use this fan with any solid state speed control.
•NOTE: Cutout dimension: 91/8" dia. for model 8010 - 111/8" dia. for 8110.
If your installation presents a problem that is not explained here or if any part of these instructions is not clear, consult a professional installer. If you are not familiar with methods of installing electrical wiring, or if you are not certain as to the correctness of any step or procedure described here, secure the services of a qualified electrician.
INSTALLING THE “A” UNIT
The “A” Unit consists of the wall sleeve assembly, outlet box and outlet box cover.
ADJUSTING THE WALL SLEEVES
1.Refer to Figure 1. Pull the inside sleeve out to the desired wall thickness for the the circular flange to be flush with the finished wall.
2.Align the slots in the inside sleeve to the holes in the outside sleeve and fasten together with screws furnished.
FIGURE 2
FIGURE 3
NOTE: The knockouts of the outside sleeve are removable to allow clearance space for the outlet box.
INSTALLING THE WALL SLEEVES
For installation into wood: nail outside panel to sheathing through holes provided in flange of outside panel.
For installation into brick: grout unit into place so that panel is flush with brick.